Instructions for Setting Up and Using the ButtKicker
®
Drum Throne Mounting Bracket
This kit contains everything you need to easily use a ButtKicker with most drum thrones
that have
evenly-spaced, four-bolt seat attachment plates.
Note: This bracket is NOT designed for thrones that have a three-bolt attachment plate. At this time we
do not manufacture a mounting bracket for these types of thrones.
Before beginning, please make sure you have the following:
.
•
One mounting plate
•
Four ¼” x 1” carriage bolts.
•
Four ¼” x 1 ¼” hex head bolts.
•
Four nuts.
•
Four star washers.
•
Wrench. Not included
•
ButtKicker LFE or Concert. Sold
separately.
•
Power Amplifier. Sold separately.
•
12 or 14 gauge speaker wire. Sold
separately.
Attach the Drum Throne Mounting Bracket to the Drum Throne:
1. Turn drum throne over and remove the existing four bolts which attach the pedestal plate to the
bottom of the throne.
2. Set the drum throne mounting bracket on the bottom of the drum throne. Line up the four holes in
the bottom of the drum throne with the four slots in the drum throne mounting bracket.
3. IMPORTANT - if any of the square mounting holes on the drum throne mounting bracket will be
covered by the bottom of the drum when after it is reassembled, you MUST install the carriage bolts
BEFORE bolting the drum throne mounting bracket to the bottom of the throne. The carriage bolts
are installed with the head of the bolt towards the bottom of the seat.
4. Place pedestal mounting plate on top of drum throne mounting bracket and line up the four holes
with ButtKicker mounting bracket slots and holes in bottom of seat.
5. Replace the throne’s original four bolts, through both bracket and mounting plate, and tighten
securely.
Note: If the throne’s original bolts are not long enough then use the ¼” x 1 ¼” hex head bolts that
came with the drum throne mounting bracket.
