English 1
PA12GRILLN Electric Grill Use
and Care Guide
The PA12GRILLN Accessory Grill Plate can be used on all
THERMADOR
®
rangetop and range models with an
electric griddle
except
for the following:
•
PRD484NCHU/C
•
PRD484NCGU/C
•
PRD48NCSGU/C
About the Electric Grill
The grill plate is a non-stick, non-PTFE cast iron grill plate.
This produces a surface with even heat that is easy to
clean.
When cooking meat on the grill you will achieve a similar
flavor as meat cooked on an outdoor grill. This flavor is
actually created by the fats and juices that are brought to
the surface of the food and seared by the heat from the grill
plate.
IMPORTANT:
•
A VENTILATING HOOD
of adequate cubic-feet-per-
minute capacity vented to the outside of the house is
strongly recommended for installation
ABOVE THE
RANGETOP/RANGE
.
The hood must be installed according to installation
instructions furnished with the hood and local building
code requirements. Refer to ventilation requirements in
the
Appliance’s Installation Instructions
for additional
information.
•
Do not use a microwave oven/ventilator combination
above the cooktop/range, as these types of units do
not provide the proper ventilation and are not suitable
for use with the cooktop/range.
•
The electric grill element is rated at 120 volts AC, 1630
watts.
Installing the Grill Plate
1. Wash the grill plate with warm soapy water then rinse
with clear water.
2. Lift up and off to remove the griddle plate from the
maintop. Replace with the electric grill plate.
3. The grill must be tilted slightly forward for optimum
performance. See the
Appliance’s Installation Manual
for procedure to check and adjust the grill for proper tilt
of the grill plate.
4. Insert the grease tray and push under the front edge of
the grill overhang to catch grease or food residue.
Insert grease tray before each use.
Insert grease tray before each use.
Insert grease tray before each use.
Grill Plate
Grease Tray
