TA04864 E Page 1 of 13
© 2016 Thomas & Betts. All Rights Reserved.
1.0 GENERAL CHARACTERISTICS ...................... Page
1.1 Description..............................................................2
1.2 Warning...................................................................2
1.3 Tool Includes...........................................................2
2.0 INSTALLING ELECTRIC DIE ........................... Page
2.1 Installation...............................................................2
3.0 TOOL PACK...................................................... Page
3.1 Tool Pack Features .................................................3
3.2 Table I......................................................................3
3.3 Catalog Number Location.......................................3
3.4 Installing Ram Tool..................................................3
3.5 Installing Stock Guide.............................................4
3.6 Alignment of Tool Packs .........................................4
3.7 Un-Installing Tool Packs .........................................4
4.0 TERMINALS & DISCONNECTS....................... Page
4.1 Overview.................................................................5
4.2 Inserting Carrier Strip..............................................5
4.3 Removing of Carrier Strip .......................................5
5.0 CRIMPING ........................................................ Page
5.1 Determine Proper Crimp Settings...........................6
6.0 SETTING ADJUSTMENTS............................... Page
6.1 Feed Control ...........................................................6
6.2 Run Mode ...............................................................6
6.3 Speed Mode Calibration.........................................7
6.4 Position Mode Calibration ......................................7
6.5 Delay Mode Calibration ..........................................7
7.0 STOCK GUIDE ................................................. Page
7.1 Wire Stop Adjustments ...........................................8
7.2 Terminal Sensor Adjustment...................................8
8.0 INDICATORS .................................................... Page
8.1 Power Supply .........................................................9
8.2 Ram Sensor............................................................9
8.3 Status LED’s ...........................................................9
9.0 SPECIFICATIONS............................................. Page
9.1 Cleaning.................................................................10
9.2 Inspection ..............................................................10
9.3 Lubrication.............................................................10
10.0 MAINTENANCE.............................................. Page
10.1 Table IV................................................................11
11.0 OPTIONS.........................................................Page
11.1 TNB197 - FUNNEL KIT
ASSEMBLY....................12
11.2 Table V..................................................................13
TABLE OF CONTENTS
IMPORTANT: Read and understand all of the instructions and safety
information in this manual before operating or servicing this tool.
OPERATING INSTRUCTION MANUAL
QUICK-KON™ AUTOMATED CRIMPING SYSTEM
for Catalog Number: TNB170-ELECDIE
