Form No. 3407-216 Rev A
Road Light and Homologation Kit
Workman
®
GTX Series Utility Vehicle
Model No. 133-7128
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
Note:
The Brake and Signal Kit (Toro Part No. 132-8579 for the Workman GTX or 133-7127 for the Workman GTX
Electric) must be installed on the machine to install this kit.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
Headlight
2
Headlight adapter
2
2
Cable tie
5
Install the headlights.
Wire harness
1
Plate light
2
Phillips-head screw (#10 x 5/8 inch)
4
Locknut (#10)
4
Plate bracket
1
3
Push fastener
2
Install the plate bracket and wire
harness.
4
Serial plate
1
Install the serial plate.
Speed plate
3
Plate-mount bracket
2
5
Pop rivet (3/16 x 0.92 inch)
17
Install the speed plates.
6
No parts required
–
Complete the installation.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3407-216* A
