Revision 1 12-15-2020
Toro Form No 3443-853 Rev A
Tool Inspection Process
Perform the necessary maintenance procedures as specified in the following table (for complete procedures, refer to the
Operator’s Manual
):
Maintenance Service Interval
Maintenance Procedure
After the first 5 hours
• Change the engine oil.
Before each use or daily
• Inspect the air-cleaner elements.
• Check the engine-oil level.
• Check the tire pressure.
• Check the blades for wear or damage.
• Check the seed gate.
• Clean the engine and exhaust area.
• Clean the debris buildup from under the machine.
• Check for loose fasteners.
Every 25 hours
• Grease the slicer-shaft bearings.
• Check the condition of the belts.
Every 50 hours
• Clean the air-cleaner elements. Clean them more frequently in dusty operating conditions.
• Change the engine oil.
• Check the spark arrester (if equipped).
• Clean under the belt cover.
Every 100 hours
• Inspect and adjust the spark plug; replace it if necessary.
• Change the hydraulic-transmission fluid.
Every 200 hours
• Replace the paper air-cleaner element. Replace it more frequently in dusty operating conditions.
• Replace the spark plug.
Yearly or before storage
• Touch up chipped paint.
Tool Rental Center
Tool Turn Guide
20in Turf Seeder
Model No.
23508—400000000 and Up
Supplier Technical Support #:
800-888-9926
(US and Canada)
Supplier Website:
www.Toro.com
PURPOSE
Follow the directions below to maintain this tool.
SAFETY
Refer to the product Operator’s Manual for complete safety information.
