Toro Dingo TX 413, Setup Instructions

Original Instructions (EN)

Trailer

Dingo TX 413 Compact Utility Loader

Model No. 22999

Form No. 3351-919

Setup Instructions

Note:

 Determine left and right sides of the machine from

the normal operating position.

Setup

Install attachment holder to the base trailer by sliding the

post on the attachment holder into the pocket on the trailer

(Fig. 1).

1

2

3

Figure 1

1. Base trailer
2. Pocket

3. License plate mount

The components used in the following procedures are

shipped loose with the trailer.

1.

Locate the attachment holder and set screws. Set screws

may be installed if not shipped loose.

2.

Place the attachment holder post into the trailer pocket

as shown in Figure 2.

1

2

Figure 2

1. Attachment holder post

2. Set screw

3.

Tighten the two set screws in the pocket to secure the

attachment holder to the trailer (Fig. 2).

4.

Remove the bolt and nut fastened to the pin on the

trailer hinge (Fig. 3).

5.

Line up the ramp hinges with the posts welded to the

trailer hinges and install the ramp by mating the posts

and hinges (Fig. 3).

6

1

3

5

4

2

Figure 3

1. Ramp
2. Trailer bed
3. Bolt

4. Nut
5. Ramp hinge
6. Trailer hinge post