Copyright 2013
All Rights Reserved
Page
1
of
2
NOTE; PERSONAL AND CUSTOM PREFRERENCES WILL BE LOST UPON COMPLETION
OF THIS FIRMWARE UPDATE. PLAEAE MAKE NOTE OF ANY PREFERENCE SETTINGS
PRIOR TO STARTING THIS FIRMWRE UPDATE.
How to upgrade the Software
1
Remove AC power from set by unplugging the AC power cord with viewing the TV.
2
The USB reader is located on the left or right of the cabinet near the side control/jack assembly as
shown in Figure 1.
Figure 1
3
Insert the
“USB Drive” into the USB slot as shown in Figure 2.
Figure 2
