background image

WARRANTY

Tower Hobbies

®

will warrant this kit for 90 days after the purchase from defects in materials or workmanship. This warranty does

not cover any component parts damaged by use or modification. Tower Hobbies will either repair or replace, at no charge, any part
deemed defective due to those causes.

Make sure you 

save the receipt or invoice

you were given when you purchased your model! It is your proof of purchase and we

must see it before we can honor the warranty.

To return your Tower Turbo Vee II for repairs covered under warranty, send your boat to:

Hobby Services 

1610 Interstate Drive

Champaign, Illinois 61822

Attn: Service Department

Phone: (217) 398-0007 9:00 am - 5:00 pm Central Time M-F

E-mail: 

hobbyservices@hobbico.com

© Copyright 2002 V1.0

TOWZ1160 for TOWB01**

THANK  YOU  FOR  PURCHASING  THE  TOWER  HOBBIES  TURBO  VEE  II

ELECTRIC  BOAT!  THIS  MANUAL  CONTAINS  THE

INSTRUCTIONS  YOU  NEED  TO  SAFELY  BUILD,  OPERATE,  AND  MAINTAIN  YOUR  ELECTRIC  R/C  BOAT.  READ  OVER  THIS
MANUAL THOROUGHLY BEFORE OPERATING THE TURBO VEE II.

ASSEMBLY AND OPERATION MANUAL

RTR

READY-TO-RUN

Summary of Contents for Turbo Vee 2

Page 1: ... see it before we can honor the warranty To return your Tower Turbo Vee II for repairs covered under warranty send your boat to Hobby Services 1610 Interstate Drive Champaign Illinois 61822 Attn Service Department Phone 217 398 0007 9 00 am 5 00 pm Central Time M F E mail hobbyservices hobbico com Copyright 2002 V1 0 TOWZ1160 for TOWB01 THANK YOU FOR PURCHASING THE TOWER HOBBIES TURBO VEE II ELECT...

Page 2: ...ENTIRE system this includes the boat and radio 2 Make sure all batteries are removed from the boat and radio 3 Send written instructions Include a list of all items returned a THOROUGH explanation of the problem the service needed and your phone number during the day If you expect the repair to be covered under warranty be sure to include a proof of purchase date 4 Be sure to send your full return...

Page 3: ...oute it through the small hole in the rear wall of the radio box Replace the radio box cover and secure it with the two 1 6 x 17mm screws 4 Run the receiver antenna wire up through the antenna tube mount the small opening located toward the rear of the hatch 5 Thread the receiver antenna wire through the antenna tube and insert the antenna tube into the antenna tube mount DO NOT CUT OFF THE EXCESS...

Page 4: ...roll of paper towels handy and dry out the hull interior after every run If you notice excessive amounts of water in the hull check for leaks especially around the hull deck joint You may reseal the joint using medium cyanoacrylate CA glue Always store your Turbo Vee II with the hatch removed to allow the interior to dry out completely Failure to do so may result in corrosion of the electronic com...

Reviews: