TPG BizPhone
P a g e
| 1 of 2
IP DECT W56P
Quick Startup Guide
Packaging Contents
The following contents are included in your W56P package:
Assembling the Phone
1.
Connect the network and power for the base station in one of
the following ways, as shown below.
2.
Insert the battery into the handset, as shown below:
3.
Connect the charger cradle and charge the handset, as
shown below:
Note:
The handset should be used with original power adapter
(5V/500Ma) only. The user of the third-party power
adapter may cause damage to the handset.
The charging status of the handset is indicated in the
top right-hand corner of the LCD screen.
Startup the Phone
The IP Phone is pre-registered to the base station. After the IP
Phone is connected to the network and the power, it will
automatically start the initialization process by connecting to TPG
BizPhone’s servers to obtain the configuration and updates
(maximum 10 minutes).
The LCD screen will indicate the current status of the process
(initializing or configuration updating). The phone may reboot few
time during this process. After the final reboot, the phone is ready
to use.
BASIC OPERATIONS
Turning Handsets On
Press
,then the LCD screen lights up.
Place the handset in the charger cradle. The handset will be
turned on automatically.
Turning Handsets Off
Long press
to turn the handset off.
