TOWING
(Fig. 2)
Undo the flap adjuster screw.
Release the pipe locking clamp and lower the pipe into the pipe locating bracket.
Tighten the flap adjuster screw.
Unhook the operating cable from the actuating arm and clip back round chassis.
Raise the rear stabiliser and lock into place.
Check lighting board operation.
Check handbrake is OFF before towing.
Check operation of jockey wheel and that it is raised before towing.
PETROL MODEL
CAMON
IMPORTANT -
PLEASE READ CAREFULLY
OPERATING INSTRUCTIONS
& SAFETY NOTES
C250 WOOD CHIPPER
No liability will be accepted for any damage caused to persons or property
through failure to observe operating and safety instructions.
SAFETY
ALWAYS
start the engine in the open air
DO NOT
smoke when refuelling
ALWAYS
stop the engine and the machine before making any
adjustments, refuelling, moving or cleaning or when the unit is unattended
ALWAYS
ensure that guards are in place when the machine is operating
or the engine is running
DO NOT
remove any safety guards that are fitted
ALWAYS
wear suitable clothing and footwear to give personal protection
ALWAYS
wear safety glasses and ear protectors
KEEP
hands, feet and clothing out of openings, discharge and moving parts
when the machine is operating or the engine is running
DO NOT
touch any moving parts or attempt any maintenance whilst the
machine is running - KEEP HANDS AND FEET AWAY
DO NOT
allow children or anyone uninstructed to operate the machine -
KEEP ANIMALS AWAY
IF A FAULT
develops DO NOT attempt any repair - immediately contact
the supplier from whom the machine was obtained
C250P/0904
Fig. 2
Teknol House, Victoria Road, Burgess Hill RH15 9LH
Tel: 01444 247689 Fax: 01444 871612
Website: www.tracmaster.co.uk E-mail: info@tracmaster.co.uk
