www.TrailFX.com
Page
1
of
2
Rev 030816
120 min
PARTS LIST:
Qty
Part Description
Qty
Part Description
1
Block Light*
2
M6 x 16mm Bolt*
1
Wiring Harness
1
M8 X 25mm Bolt*
1
Switch
2
M6 Lock Nut*
1
U Bracket*
1
M8 Hex Nut*
1
Lock Washer*
*Part quantity doubles for the paired kits
LIGHT INSTALLATION:
1. Install supplied bracket to block light using M6 x 16mm bolts and M6 Lock Nuts. Insert bracket into vents on back of block light
and then, insert M6 lock nuts into the open cavities next to inserted bracket. Once both have been placed, insert m6 x 16mm
bolt into hole on side of block light. Repeat on opposite side of light.
2. Identify the desired mounting location for the lights on the vehicle. Place block light and mark bracket hole locations on vehicle
(If mounting hole requires drilling).
3. If mounting hole requires drilling, drill a 5/16" hole in locations marked.
4. Mount using M8 x 25mm bolt, lock washer, and M8 hex nut. Once Light bar is in desired location tighten all hardware.
3” LED 18W Cube Light
Part No:
2123131, 2123131P, 2123141, 2123141P
tools may be required
1 866 638 4870
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE
PRESENT.
support@trailfx.com
READ INSTRUCTIONS CAREFULLY BEFORE STARTING
INSTALLATION.
BLOCK LIGHT
WIRING HARNESS
SWITCH
MOUNTING KIT
To Harness
