ve
rs
io
n 0
6
/2
0
19 E
N
de
si
gn R
ed
ty
pe
TRANSFORM.EU
3
5
2
B
3
4
C
REC OMME NDE D MOUN T ING IN S T RUC T ION S
TALL FLOWERBED MOUNTING SET ELEMENTS MADE OF THE TRAPLAST™
Universal mounting instructions for single chamber flowerbed! Model size 1200 × 660 × 530 mm (w × d × h). Regardless of the size/type of
flowerbed purchased, always use shorter decking boards
1
and
3
for faces and longer decking boards
2
and
4
for sidewalls. Validate
a number of decking boards forming the wall of your particular flowerbed by comparing with the picture shown on www.recyklace.cz/eshop.
BEST PRACTICE OF MOUNTING TALL FLOWERBED
1
decking board 132 × 32 × 600 mm*, 6 pcs*- for faces
2
decking board 132 × 32 × 1200 mm*, 6 pcs* - for sidewalls
3
decking board 132 × 32 × 600 mm*
(without groove with spring), 2 pcs
4
decking board 132 × 32 × 1200 mm*
(without groove with spring), 2 pcs
5
joist 50 × 50 × 520 mm*, 4 pcs
6
screw with recessed head 6 × 70 mm, white zinc-plated, 64 pcs*
We recommend to assemble the Tall Flowerbed made of the Traplast™
where it will stand taking into account its total weight. The joist
5
is
slightly shorter than the resulting height of the flowerbed sidewall, so
decide first whether it will face up with the bottom or upper edge of the
sidewall - see the Figure A. If you have selected the facing up with the
upper edge of the sidewall, lay a shorter board on two parallel joists
3
. The
upper decking boards
3
and
4
do not have spring and the groove is at
the bottom - see the Figure D. When facing up the joists and the decking
board at the bottom, start with the decking board
1
while the groove
is facing down again. Align the joists with the sides of the decking board
and drill a 4 mm diameter hole in its longitudinal axis up to the joist in the
distance of 25 mm from each side of the floor. Screw the decking board
using the screws
6
and assemble the face using other decking board.
Attach the decking board
2
to the face as shown in the Figure B. Predrill
the holes for the screws (up to the joist again) in the horizontal axis of the
D
3
1
4
2
!
When working / assembling, use the protective equipment!
TALL FLOWERBED
SINGL E CH A MBE R
* The values given are for the flowerbed version in the size of 1200 × 660 × 530 mm (width × depth × height). The number of pieces and their length vary according to the chosen size of the flowerbed.
3
6
5
5
1
1
1
A
decking board so that they point to the middle of the joist. We recommend
you to horizontally set off the holes from the top and bottom edges of the
deck a little differently than on the already assembled face so that screws
avoid each other in the joist. Gradually screw other four decking boards
2
one after the other and end with the decking board without the spring
4
.
