background image

COMPLIANCE INFORMATION

UL Listed 
C-UL Listed (Canada)
CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules.  These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.  This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.  Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on
the radio interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables

aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique
édicté par le ministère des Communications du Canada.

European Regulations

Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Achtung !
Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes
Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen
werantwortlich ist.
Attention !
Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques
appropriées

Copyright Restrictions

© 1999 TRANSITION Networks.
All rights reserved.  No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners.
Printed in the U.S.A.

33049.F

Designed to be installed in the TRANSITION Networks E-MCC-1600 Media
Converter Chassis,

C/E-TBT-FRL-03

series 10BASE-T/10BASE-FL media
converters connect either half-
duplex or full-duplex, unshielded or
shielded 10BASE-T twisted-pair
copper to either half-duplex or full-
duplex 10BASE-FL multimode fiber. 

CAUTION:  RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität. 

Minneapolis, MN  55344  USA

10BASE-T/10BASE-FL

Slide-In-Module Media Converters

C/E-TBT-FRL-03, C/E-TBT-FRL-03(SC), C/E-TBT-FRL-03(SM), 

C/E-TBT-FRL-03(L), C/E-TBT-FRL-03(MT), C/E-TBT-FRL-03(XC)

USER’S GUIDE

C/E-TBT-FRL-03 

Provides an RJ-45 unshielded twisted
pair 10BASE-T connector and a set of
RX (receive) and TX (transmit) ST
10BASE-FL 850nm multimode fiber
connectors. 

C/E-TBT-FRL-03 (SC)

Provides an RJ-45 unshielded twisted
pair 10BASE-T connector and a set of
RX (receive) and TX (transmit) SC
10BASE-FL 850nm multimode fiber
connectors. 

C/E-TBT-FRL-03(SM) 

Provides an RJ-45 unshielded twisted
pair 10BASE-T connector and an RX
(receive) and TX (transmit) ST 10BASE-
FL 1300nm singlemode fiber
connector. 

C/E-TBT-FRL-03(L) 

Provides an RJ-45 unshielded twisted
pair 10BASE-T connector and a set of
RX (receive) and TX (transmit) ST
10BASE-FL 1300nm multimode fiber
connectors. 

C/E-TBT-FRL-03(MT) 

Provides an RJ-45 unshielded twisted
pair 10BASE-T connector and an RX
(receive) and TX (transmit) MT-RJ
10BASE-FL 850nm multimode fiber
connector. 

C/E-TBT-FRL-03(XC) 

Provides an RJ-45 unshielded twisted
pair 10BASE-T connector and an RX
(receive) and TX (transmit) SC 10BASE-
FL 1300nm singlemode fiber connector. 

C/E-TBT-FRL-03 in the Network  .2
Installation  . . . . . . . . . . . . . . . . .3
Operation . . . . . . . . . . . . . . . . . .4
Fault Isolation and Correction  . .5
Cable Specifications  . . . . . . . . . .6
Technical Specifications  . . . . . . .7
Compliance Information . . . . . . .8

850nm

Multimode

Fiber

10BASE-T

Copper

Ethernet

TM

C/E-TBT-FRL-03

P

C/E-TBT-FRL-03

Summary of Contents for C/E-TBT-FRL-03(L)

Page 1: ...arks are the property of their respective owners Printed in the U S A 33049 F Designed to be installed in the TRANSITION Networks E MCC 1600 Media Converter Chassis C E TBT FRL 03 series 10BASE T 10BASE FL media converters connect either half duplex or full duplex unshielded or shielded 10BASE T twisted pair copper to either half duplex or full duplex 10BASE FL multimode fiber CAUTION RJ connector...

Page 2: ...5344 USA Model C E TBT FRL 03 Series Copper to Fiber Media Converter Part Number C E TBT FRL 03 C E TBT FRL 03 SC C E TBT FRL 03 SM C E TBT FRL 03 L C E TBT FRL 03 MT C E TBT FRL 03 XC Regulation EMC Directive 89 336 EEC Purpose To declare that the C E TBT FRL 03 to which this declaration refers is in conformity with the following standards EMC CISPR 22 1985 Class A EN 55022 1988 Class A EN 50082 ...

Page 3: ...he active pairs INSTALLATION Set MDI MDI X Switch NOTE Straight through crossover 10BASE T requirements are satisfied using the MDI MDI X switch with straight through cable See page 6 for cable configurations Using small flatblade screwdriver or similar tool and referring to label at front of media converter set MDI MDI X switch position for site installation 10BASE T cable connections between a h...

Page 4: ...OLATION and CORRECTION If the media converter fails isolate and correct the fault by determining the answers to the following questions and then taking the indicated action 1 Is the P ower LED on the media converter illuminated NO Is the media converter inserted properly into the E MCC 1600 chassis Contact Technical Support at 800 260 1312 800 LAN WANS YES Proceed to step 2 2 Is the green 10BASE T...

Reviews: