Rear Blower Installation Instructions
99000138
Page 1 of 6
17601035 - 8/18/10
© Travis Industries, Inc.
Compatibility (Freestanding Models Only)
• Lopi Answer • Lopi Endeavor • Lopi Liberty • Lopi Leyden
• Avalon Pendleton (745/790) • Avalon Rainier (945/990) • Avalon Olympic (1190) • Avalon Arbor
• 1250 Wood Stove • 1750 Wood Stove
Packing List
• Rear Blower • Snap Disk Assembly • Snap Disk Hanger • Three 1/4" 20 Thread Cutting Screws
Operating Instructions
The blower will not turn on until the appliance is up to temperature. Once up to temperature, the blower will
operate at the speed determined by the position of the blower knob (see the illustration below). The blower
shuts off once the appliance cools.
Installation Instructions (All Except Leyden, Arbor, and 1750)
1. Install the stove legs or pedestal. Remove the two rear blower knock-outs underneath the base (see the
illustration below).
2. For the Endeavor and Liberty follow step 2B. For all other models, follow step 2A.
2A Install the snap disk assembly into the left side convection chamber following the directions below.
OFF
Turn the knob
all the way
counter-
clockwise to
turn off.
HIGH
Turn the knob
clockwise from
the off position
until it clicks.
LOW
Turn the knob
all the way
clockwise to
turn to low.
Outside Air Knock-Out
for standard pedestals
Drop Chute Knock-Out
- found on Olympic
(1190) and Rainier (990)
only.
Rear Blower Knock-Outs
Ashpan Pedestal/Air Boot
Outside Air Knock-Out
FRONT OF STOVE
REMOVE THESE KNOCK-OUTS
Ashlip
Bend these legs on
the snap disk if it
does not fit tightly
Wedge the snap disk
directly in front of the
stiffener on the left side.
Twist the wires together and feed them
through the convection chamber and
out of the knockout removed in step 1.
Snap Disk
Assembly
