R/C ATV USER’S GUIDE
ATV: AAA x 3
Controller: 9V x 1
• Please install 3 “AAA” fully-charged batteries into the chassis battery box, and
screw on cover.
• Place 1 “9-Volt” battery into the battery box of radio controller and screw on cover.
• Place radio control ON/OFF switch in the “ON” position, then the vehicle’s ON/
OFF switch to the “ON” position.
• Do not mix old and new batteries together.
• Do not dispose of batteries in fire. Leakage, explosion and/or personal injury may occur.
• Dispose of batteries properly.
• Always remove the batteries from the battery box when not is use for extended periods.
• Only an adult should charge rechargeable batteries.
• Only use batteries of the same or equivalent type as recommended.
• Only insert batteries with the correct polarity.
• Remove rechargeable batteries from the battery box before recharging.
I N S T R U C T I O N S
C A U T I O N :
This Category II radiocommunication device complies with Industry Canada Standard RSS-310.
Warning: The manufacturer is not responsible for
any radio or TV interference caused by unauthor-
ized modifications to this equipment. Changes or
modifications not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment.
Front Wheels
Front Wheels
Forward/
Back
Left/
Right
Battery
Compartment
Battery
Compart-
ment
Rear Wheels
Top
Bottom
Rear Wheels
B A T T E R Y P L A C E M E N T :
C O N T R O L L E R :
T O P V I E W :
B O T T O M V I E W :
Manufactured by:
Tree House Kids, Inc.
Corona, CA USA
™
MADE IN CHINA
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
