1
TREX
®
DECKLIGHTING
™
Installation Instructions
A
B
C
D
E
PARTS
A
B
C
D
x2
x2
x2
x2
x2
x2
x2
x2
A
Pyramid Post Cap Light
Riser Light
Splitter
Deck Rail Light
Recessed Deck Light
B
C
D
E
x2
x2
x2
x2
Flat Post Cap Light
NOTE:
All wiring and splitters are mounted to the inside
of framing. Picture above is a general representation of
where to place them.
WARNING:
» DO NOT INSTALL DECKLIGHTING IN CLOSE
PROXIMITY TO POOLS OR HOT TUBS,
AS CHEMICALS FROM THE WATER CAN
DAMAGE LIGHTING FIXTURES.
» DO NOT INSTALL WIRING UNDER HEAVY
WEIGHT OR LOAD AS THIS CAN DAMAGE
WIRING.
Lighting and Wiring Overview
1/2"
(13 mm)
1"
(25 mm)
TOOLS NEEDED
» 5ft, 10ft, 20ft, 40ft, and 60ft connection/
extension wires sold separately (these are
male-to-male connection wires).
HELPFUL TIPS
» Please note that Trex lighting operates on DC
power.
NEVER
mix AC and DC fixtures on the
same circuit. Doing so will result in extremely
premature fixture failure and is not covered by
the Trex limited warranty.
You must use a Trex
transformer on all Trex lighting installations.
»
Never fully drive staples when securing wire.
Wire should move under staple.
»
ALWAYS
protect any wire that is close to the
ground with conduit or wire loom to prevent
rodent damage.
» Cap all unused female connections with caps
(provided) or weather-resistant silicone to
prevent water damage or corrosion.
» Each dimmer operates on a separate remote.
» It is recommended to have power source
installed and turned on when installing lights to
ensure all components work.
» When installing wiring, avoid extreme angles,
pressure, or tension on the wiring, as this can
cause pinching of the wiring and create a
lighting failure.
NOTE:
Avoid railing brackets and locations for deck rail
lights when running wires up posts.
NOTE:
Install wiring and splitters before decking and rail-
ing have been installed.
DO NOT
run wires between joists
and deck boards.
HOW TO INSTALL TREX
®
DECKLIGHTING
™
www.SolarPostCapsDirect.com | (800) 878-7829 | Sales@SolarPostCapsDirect.com
