Thank you for purchasing your TRILAB DeltiQ 2 printer. Before you begin using your new machine,
please familiarize yourself with this manual. We wrote it so that you can avoid damage due to
malpractices and maximize the quality of your future prints.
Unless otherwise stated, all of the instructions herein are simple and do not require excessive force.
Should you encounter a procedure where your muscles tense up greatly and nothing happens, please
consult this manual again.
In the case that this manual doesn’t answer your question(s), please contact our support team at
Safety instructions
Your safety and well being is our priority, so please follow these instructions when using your printer:
The printer shall only be operated by trained personnel.
The printer shall be operated only under supervision. In the event of a malfunction or unusual
printer behavior, stop printing and shut down the printer.
Power to the printer is supplied by high voltage. Always turn off the printer and unplug the
power cord before accessing the power supply.
The printer contains moving parts and therefore, do not interfere with the printer during
printing. The printer can start moving without any notice and can cause injury.
Adhere to the following values for proper printer operation:
Operating temperature 20 – 32 °C (68 – 90 °F)
Storage temperature 0 – 32 °C (32 – 90 °F)
Emergency STOP
The printer is equipped with a red emergency shut off switch – EMERGENCY STOP, placed at the top of
the printer. Once pushed, this switch deactivates any ongoing operation, such as printing,
disconnecting heated components, and stopping printer movement. After a short pause, the print
head cooling fan will reactivate should the head remain hot. This function is to prevent the head from
clogging and therefore, do not turn off the printer immediately after using the EMERGENCY STOP
switch during printing.
