background image

Roll Up Door Opener Lock Kit Installation Instructions 

SW1

JP1

LED

JP2

SW2

01

fi g

02

fi g

03

fi g

INSTALLATION INSTRUCTIONS  |  OWNERS COPY

Wireless Digital Keypad

 TrioCode® KPX-6

TrioCode® Wireless Digital Keypad is designed for use 
with automatic garage door and gate openers. The 
TrioCode® format provides unparalleled security with 
more than 99 million different codes. To operate, the 
user enters their unique pin code on the KPX-6 keypad 
(4 to 8 digits long) followed by the hash (#) key. The user 
then presses one of the eight available channels.

Familiarise yourself with the following instructions prior 
to commencing set up. Store this information including 
your new pin code in a safe place for future reference.

Initial Set Up

The Keypad is supplied with a factory preset code (1111) 
which must be changed to a new pin code before the 
Keypad will operate. The pin code can be any 4-8 digits 
number except 1111.

Storing your pin number

Note: There is a timeout of approximately 5 seconds 
after the last button is pressed.

Enter 1111 followed by the hash (#) key.
Press and hold the hash (#) key again. The keypad  
will beep for approximately 5 seconds. Once the 
beeping stops, release the hash (#) key. Enter the 
new pin code followed by the hash (#) key. Re-enter 
the new pin code followed by the hash (#) key to 
confi rm. A short string of beeps will be produced to 
confi rm the acceptance of the new pin code.
Test operation using the new code. Enter the 
new code followed by the hash (#) key. Press  and 
hold any button from 1-8 and you should hear a 
continuous string of beeps.

 
NOTE: If you lose or forget a code, you will need 
to return the Keypad to Automatic Technology for 
reprogramming. A charge will apply for this service.

Coding The Keypad Into The Opener

Press and hold the Door Code button on the control 
panel of your Automatic Technology TrioCode® 
garage door opener

 (Fig. 02)

 or SW1/SW2 on the 

TrioCode® receiver board 

(Fig. 03)

Enter your pin code on the Keypad of the KPX-6 
followed by the hash (#) key then press one of the 
eight (channel) buttons you wish to use to operate 
the door or gate etc.
Pause for a second and press the same button 
again on the Keypad of the KPX-6.
Release the Door Code or SW button. The Keypad 
code should now be stored into the opener’s 
memory. 
Test the operation of the Keypad by entering your 
pin code followed by the hash (#) key and the stored 
channel button (1-8). The door or gate should start 
to move.

a.
b.

c.

a.

b.

c.

d.

e.

Star(*) key

Hash(#) key

Part # 13259 Manual v1.02

Reviews: