.39
1.00
3.86
Fig. 2
The installation template at the end of this manual can be used to drill a mounting
hole for the
Micro
IQ
. Wood screw or self-tapping metal screw options are provided.
In addition, double stick tape can be used solely or in conjunction with the mounting
screw to further secure the lock. Allow tape to cure for 72 hours.
Prior to installation and insertion of the battery, the knob of the lock mechanism will
be free moving. The
Micro
IQ
hardware contains a cam stop (#6) for both 90 and for
180 degrees. Select and install the desired cam stop and cam(#7). Position the cam
stop so the knob rotation is clockwise or counter-clockwise as desired.
1
Contents
1
R
O
TM
UTILITY LOCK - MODELS:
UT UM UA
Installation Manual
FOR OFFICE FURNITURE, STORAGE CABINETS, LOCKERS, SAFES, VAULTS, SECURED ENCLOSURES
See
Figure 1
for available mounting hardware for the
Micro
IQ
. When mounting
the
Micro
IQ
to a cabinet door or drawer, a separately mounted handle should be
used to operate, open and close the door or drawer.
Installation
When installing the lock to the cabinet/drawer, you have the option to fasten the
lock body with a nut or a retaining clip. A ‘wonder’ washer (#3) is provided for
installation in a drilled hole through either wood or metal panels.
Additional mounting fasteners (10) and/or double sided tape are provided and
must be added through the battery extremity of the housing. Select the fasteners
that best fit your panel material and thickness. If drilling is needed for thick
panels, drilling template provided on page 13.
14
1
13
11
2
Fig. 1
10
15
#4
M 3
M 3
Lock Housing with keypad and infrared receiver
Cap with cover
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Locking cam
(per request)
Clip spring
Cam nut
(not provided with 3/8” shell)
Cam screw
Mounting screws (only 1 needed)
Mounting nut
Mounting washer
180° Cam stop
90° Cam stop
Adapter (
USE ADAPTER P/N 13346 FOR 9mm CAM HOLE EUROLOCK
)
Hex tool (1.5mm)
Temper proof battery holder screw
3M - VHB 4952 Foam tape (optional)
12
4
3
5
6
7
8
9