Troy-Bilt TB2BP EC, Operator'S Manual

IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.

Remove Unit From Carton

Assemble The Unit

Place a hose clamp over 

the end of the Flex Tube 

and slide the end of the 

with the clamp on it over 

the elbow tube. Tighten 

the clamp screw.

Place a hose clamp over 

the other end of Flex Tube 

and slide the end over the 

top end of the upper 

blower tube. Tighten the 

clamp screw.

Assemble The Unit

Loosen the 2 screws on 

the throttle control. Move 

the throttle control to the 

position that provides the 

best grip and tighten.

Mix thoroughly in separate 

fuel can:

  –  3.2 fl. oz. of 2-cycle 

engine oil 

  –  1 gallon of unleaded 

gasoline 

NOTE: Do not mix directly 

in fuel tank.

Press primer bulb 10 

times, or until fuel is 

visible

Move choke lever to 

Position 1.

Press down cruise control 

to 

FAST position.

Crouch in starting 

position.

Pull rope 5 times.

Move choke lever to 

Position 2 .

11

2

Remove all contents from 

the carton.

6

7

9

10

3

Insert the upper blower 

tube into the lower blower 

tube and twist the lower 

tube clockwise unit it locks 

into place.

Place unit on a level 

urface and fill fuel tank. 

DO NOT overfill.

8

4

Start The Unit

11

12

13

14

10 X

5 X

Starter Rope

Flex Tube

Throttle Control

On/ Off Switch

Lower Blower Tube

Nozzle

DIDN’T START?

Repeat these instructions.

IF the engine hesitates, return the choke lever to 

Position 2 and continue the warm-up.

IF the engine does not start, go back to step 9.

IF the unit fails to start after 2 attempts, move choke 

lever to Position 3 and pull rope until unit starts

Primer

Bulb

Move choke lever to 

Position 3.

Continue to keep the 

cruise control in FAST 

position and warm unit for 

an 

additional 60 seconds 

to complete warm-up. Unit 

may be used during this 

time.

16

17

Pull rope 3-5 times to 

start engine. 

Keep the 

cruise control in FAST 

position and allow unit to 

warm up for 30 to 60 

seconds.

15

Primer Bulb

Tools Required-

Phillips Screwdriver

T-20 Torx

®

 Screwdriver 

Insert the lower blower 

tube into the nozzle and 

twist the nozzle clockwise 

until it locks into place. 

Zip tie the throttle cable to 

the elbow tube.       

5

Upper Blower

Tube

Fuel Cap

Choke Lever

Cruise Control

1 Gallon

3.2 oz

40:1

SLOW

FAST

SLOW

FAST

Start The Unit

Spark Plug

Operator’s Manual

769-07848 P00 

04/12

NEED HELP?

Call 1-800-828-5500 in U.S. or 1–800–668–1238 in Canada

ENGLISH — P

AGE 1

ESP

AÑOL — P

AGE 7

TB2BP EC

2-Cycle

Electric Start Capable 

Backpack Blower