TRUST AMI MOUSE 250S OPTICAL E-MAIL
1
U K
1 Introduction
This manual is intended for users of the TRUST AMI MOUSE 250S OPTICAL E-
MAIL. It works on nearly all surfaces. Every time you receive a new e-mail, LED in
the mouse will light up. The mouse has 5 buttons, 3 of which are programmable.
This mouse checks for new e-mail at regular intervals.
2 Safety
1.
Never use this device in a damp environment, such as bathrooms, damp
basements, near swimming pools and so on.
2.
Do not attempt to repair this device yourself.
3.
Place the device in such a way that the cable cannot be damaged.
3 Connection
This mouse can be connected to the USB port of your computer. Consult your
computer’s manual to verify if your system has such a port.
Note:
Do not connect this mouse to a serial or PS/2 port.
1.
Remove the software of the former mouse.
2.
Detach the former mouse and turn off the computer. If your previous mouse
was connected to the PS/2 port, you could also leave it connected.
3.
Connect the Ami Mouse 250S Optical Email to the USB port of your
computer and switch on the computer.
4.
The mouse will be auto-detected and installed. You can use the mouse as a
standard, two-button mouse.
5.
Continue with section 4 for the software installation.
4 Software
installation
1.
Place the CD-ROM in your CD-ROM player. The Installer will start up
automatically.
If it doesn’t, take the following steps:
a)
Select ‘Execute’ in the start menu.
b)
Type [D:\SETUP.EXE] and click ‘OK’ in order to start up the Trust
Software Installer.
2.
Figure 1 will appear.
3.
Select the language you wish to use during the installation.
4.
Click on 'Ami Mouse 250S Series‘ to start up the installation of the mouse
software.
5.
Follow the steps that appear onscreen.
6.
If ‘select device type’ appears, select ‘12523 AMI MOUSES OPTICAL
EMAIL’.
7.
After the installation of the mouse driver / software you install the e-mail
software by clicking the button ‘E–Mail Mouse Software’. See Figure 1.
8.
Follow the steps that will appear onscreen.
9.
After completion of the installation, you have to restart the computer.
Note:
The CD-ROM player is referred to as “D:\” as an example, but this may
differ per computer.
