C
This diagram illustrates possible layouts for the
LED STRIP.
Refer to the Component Overview for additional information.
Strip Dimension
Component Layout with IP65 connectors
Front view
30mm
12mm
175mm
25mm
Side view
3.4mm
Warm White
(2400K)
Warm White
STRIP
(2700K)
Neutral White
(4000K)
Input Voltage
Input Current
Beam Angle
Lumen/ Meter
CRI
No. of LED/Segment
Weight
Power
LED Pitch
IP Rating
Operating Temp.
StorageTemp.
Min. Bending Radius
Dimming
Max. Connection Length
24V
8W/m
61.5g/m
80
7pcs
IP20,IP65,IP68 denpending on connector use
o
o
-20 ~ 50
o
o
-25 ~ 60
60mm
o
120
J
OR
Power Supply
I
E
P
S
AC
I
J
P
S
L
Connectors
E
End Cap
I-Connector
L-Connector
PS-Link Connector
4 Way Power Splitter
Jumper Cable
Yes,with inline dimmer
Cut strip to desired length along the cut mark indicated
A
T-Connector
With the LED side facing up, slide one strip into the opening in bottom half of one side of the connector until it reaches the end.
Repeat with the other strips in the other sides of the connector if required.
PS-Link Connector
I-Connector
Jumper Cable
All connectors only use once.
!
Install Connectors
Using pliers, apply even pressure to the bottom and top halves of the connector to push connector together, securing strip inside.
C
T-Connector
PS-Link Connector
I-Connector
Jumper Cable
!
Install End Cap
Slide End Cap onto strip that will have no connector. The End Cap protects the strip.
Install 4 Way Power Splitter
Match the icons on each PS-Link Connector with the icons on the 4 Way Power Splitter. Repeat the same connection method
with the power supply and the 4 Way Splitter.
Push the strip completely into the connector.
B
Push to the stop!!!
IP 65 Connectors
4 Way Power Splitter
Connects four strips to one power supply. Install between power supply and four PS-Link
connectors.
End Cap
Used in ALL installations. Protects end of strip that is not connected to a connector.
I-Connector
Connects two lengths of strips in a straight line. Use to extend a length of strip.
PS-Link Connector
Used in ALL installations. Connects strip to power supply.
L-Connector
Jumper Cable
Connects two strips.
Model
Description
65
Stri
450mA/m
750lm
25mm
10m
Ordnen Sie die Symbole auf jedem PS-Link-Anschluss den Symbolen auf dem 4-fach-Leistungsteiler zu. Wiederholen Sie die
gleiche Anschlussmethode mit der Stromversorgung. und den 4-Wege-Splitter.
.
.
E
J
J
E
P
L
E
Connects two strips.
L-Connector
L-Connector
IP
Strip can be cut every 17.5cm.
Warm White
(2400K)
Bright White
(3000K)
Warm White
(2400K)
Neutral White
(4000K)
Warm White
(2400K)
Cool White
(6500K)
750lm
800lm
800lm
