Turbo T40040, Manual

1

2013    

 TURBO

     Printed in Canada     

TI026

TO THE PROFESSIONAL OR INSTALLER: 

Instructions must remain with installation.

GENERAL EASY FLUSH SYSTEM 

INSTALLATION

Please read these instructions carefully. 
Note before you proceed with the 
installation of this product that the 
manufacturer’s guideline has to be 
respected. Failure to comply to instructions 
and designed operation of this product,  
may void the warranty.
Your product has been carefully packaged 
at the factory to prevent damage during 
shipping. However, occasional damage 
may occur due to rough handling. Carefully 
inspect your product for damages that could 
cause failures. Report any damage to your 
carrier or your point of purchase.

INITIAL START UP PROCEDURES:
1-  

Inspect the pump and the sewage tank for 
any obvious condition that may necessitates 
cleaning, correction, adjustement or repair.

2-  

Assure that the pump is secure and vertical 

for proper operation.

3-  

Assure that there is adequate clearance 
from any combustible materials or structure. 
Stored materials must be kept away from 
the pump.

4-  

Assure that the motor is securely plugged 
into a proper 'GFCI' electrical outlet.

5-  

Test the 'GFCI' outlet by pressing its test 
switch. This should prove that the outlet 
is energized and will trip off to protect 
against a ground fault. Be sure to reset 
the 'GFCI' by pressing its reset switch. 

(Repeat this step monthly)

6-  

Lift the float to assure that the pump will 
start when required. (Step 7 below will test 
submersible pumps with enclosed floats).

7-  

Pour pails of water in the sewage tank to 
turn the pump on. Assure that any check 
valve present will permit the sewage to flow.

8-  

Observe that the plumbing can pump 

the sewage safely out of the residence.  
(Repeat this step monthly)

SAFETY INTRUCTIONS:

Before installation and operation, follow these  

procedures:

A-

Check with your local electrical and 

plumbing codes to ensure you comply with 

the regulations. These codes have been 

designed with your safety in mind. Be sure 

you comply with them.

B-

  A separate circuit must be lead from the 

home electrical distribution panel properly 

protected with a fuse or a circuit breaker. We 

also required that a ground fault circuit be 

used as well as a 'GFCI' receptacle. Consult a 

licensed electrician for all wiring.

C-

  The ground terminal on the three prong 

plugs should never be removed. They are 

supplied and designed for your protection.

D-

  Never make adjustments to any electrical 

appliance or product with the power 

connected. Do not only unscrew the fuse 

or trip the breaker, remove the power plug 
from the receptacle.

IMPORTANT  
ELECTRICAL CONNECTION:

For pumping systems using more than one 

pump, each pump needs to be connected to a 

separate dedicated circuit protected by a fuse 

or breaker. This way, the power supply of one 

pump will not stop operating if the fuse of one 

of the pumps burns or if the breaker of one of 
the pumps trips.

IMPORTANT NOTICE:

The following are minimum requirements in 

order to protect your residence from flooding. 

It is a small investment but it is your personal 

responsibility to protect your home, family and 

valuables. Failure to comply with the following 

requirements will also void your warranty:

-

 An Alarm system model T50454 has to be 

installed to advise you of any malfunctions.
Pump selection, proper and adequate 
installation are a must to comply with local 
by-laws and need to be adhered to.