PAGE 1 OF 6
0421 IH-1903
1-800-295-5510
uline.com
HEAVY DUTY
GLUE GUN
π
H-1903
OPERATION
1. Fasten output control adjuster.
2. Plug in to a 110 volt outlet.
3. Insert glue stick into back of gun.
4. Pull trigger several times until glue is set firmly into
the inlet tube.
5. Turn ON/OFF switch on.
6. Adjust temperature knob to desired temperature.
7. Allow 3 minutes to warm up gun and glue stick.
8. Apply appropriate amount of glue by squeezing
trigger.
9. The output volume of glue can be adjusted by
turning the output control adjuster. Turn clockwise for
less glue and counterclockwise for more.
NOTE: Use short nozzle for general use or long
nozzle for harder to reach areas.
10. Bond surfaces by pressing together within 15
seconds after applying hot glue. For best results,
surfaces should be clean of any oil and dirt.
11. Always use the provided wire support stand in
between uses when gun is plugged in.
12. Never lay gun on its side while it is still hot.
13. After use, always switch gun to off, unplug gun and
use provided wire support until gun has cooled
before storing.
14. Never pull glue sticks out of gun.
15. If glue drips excessively, replace the nozzle. To
change, heat the gun for a minute until glue is
softened enough to remove the nozzle. While
wearing gloves, use a wrench to remove the old
nozzle. Flush glue through the gun and attach the
new nozzle.
Output Control
Adjuster
Temperature
Knob
Wire
Support Stand
ON/OFF Switch
Small Wire
Support Stand
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
