U-Line H-3415, Manual

PAGE 1 OF 12 

0814 IH-3415

π

  H-3415

AUTO FOAMING

SOAP DISPENSER

1-800-295-5510

uline.com

APPLYING DISPENSER LABEL

1.  Peel label from 

backing. The 

adhesive is on the 

FRONT of the label. 

(See Figure 1) 

2.  Open dispenser. 

Place label sticky side 

down on the INSIDE of 

the clear oval window. 

(See Figures 2-3) 

3.  Close front of 

dispenser.  

(See Figure 4) 

MOUNTING INSTRUCTIONS

For most applications, tape mounting is adequate. 

For porous, textured or wallpapered surfaces, screw 

mounting or a combination of screw and tape 

mounting is recommended. 

TAPE MOUNTING

1.  Important! Dispenser opens 

to the front. For ideal 

placement, the dispenser 

should be mounted 3" 

above any countertop, 

fixture or obstruction, and 2" 

below any cabinet, fixture or 

obstruction. (See Figure 5) 

2.  Clean the mounting surface 

thoroughly using any type 

of general purpose cleaner 

and a paper towel.  

(See Figure 6)

NOTE: Be certain 
surface is completely 

dry before proceeding.  

3.  Remove the protective 

backing from the tape 

pad on the back of the 

dispenser. Make certain 

that the mounting surface 

is clean and dry. Carefully 

position the dispenser to the 

desired location and press 

firmly to the surface for 30 

seconds. (See Figure 7)

INSTALLATION

Electric Drill

Phillips Screwdriver

TOOLS NEEDED

LabelFront

Figure 1

2"

11"

7.5"

3"

Figure 5

Figure 6

Figure 7

Label

Front

Adhesive Side

Dispenser Door

Opened

Dispenser Door 

Opened

Figure 2

Label

Back

Figure 3

Label

Front

Figure 4

Para Español, vea páginas 5-8.

Pour le français, consulter les pages 9-12.