background image

PAGE 1 OF 3 

0716 IH-5663

π

  H-5784

FLOOR SAFE

1-800-295-5510

uline.com

TOOLS NEEDED

HARDWARE INCLUDED

Drill

70mm Lag 

Screw x 2

Washer x 2

40mm Plastic Anchor 

x 2

7/16" Drill Bit

3/8" Drill Bit

Phillips Screwdriver

17mm Wrench

USAGE

IMPORTANT! Record the serial number from the 
tag on the back of the safe or from the tag on 
the front bottom corner of the safe.

Keep keys and combination in a secure place, 
away from children.

Do not store the backup key, your combination 

or this document in the safe.

WARNING! Keep your safe closed and locked 
at all times when not in use. Children could 
accidentally be locked inside the safe.

Do not move this safe using its handle. The 
handle should only be used for opening and 

closing the door of the safe.

Do not store electronic media, computer disks, 
audio-visual media or photographic negatives 
in this safe. This material will not survive the 
rated internal temperature of the safe. This 
material may be damaged or destroyed.

BATTERY INSTALLATION

1.  You must first install the battery, which is located in 

the front protective styrofoam.

NOTE: When changing the battery, always 
hold the battery connecting cap while 

disconnecting or attaching the battery. Do not 

pull on the wires. Doing this could cause the 
power supply to become disconnected from 
the lock.

2.  This safe uses one 9V alkaline battery.

3.  When the battery is low and you press a button on 

the keypad, a red light will come on warning you 

that the battery is low.

4.  To replace the battery, remove the cover by pressing 

the tab and turning the cover. (See Figure 1) 

5.  Replace the old battery and screw the cover back 

in place.

ELECTRONIC LOCK

1.  After installing the battery, to open an electronic 

lock the first time, press the following numbers/

symbols on the electronic keypad in this order: 

1-5-9-#. These numbers are preset.

NOTE: You should change the entry code as 
soon as possible after opening the safe to 

ensure proper security.

2.  After you have entered the factory code, you will 

need to turn the handle clockwise to open the door. 

You will have 5 seconds to turn the handle before 

the locking mechanism is reactivated.

Figure 1

Reviews: