PAGE 1 OF 9
0919 IH-7805
π
H-7805
MAGNETIC GLASS
DRY ERASE BOARD – 8 x 4'
1-800-295-5510
uline.com
PARTS
SETUP
WARNING! Glass dry erase boards are made
of safety glass, but improper handling and
installation may cause serious injury if the
board shatters. Proper installation will require
at least two people.
1. Make sure wall is flat. On drywall and stud walls,
always hit studs (if possible). A minimum of 1/2"
drywall is required. Use correct type anchor and
predrill for the wall type.
IMPORTANT! Do not use unless all screws are tight.
At least every six months, check all screws to be
sure they are tight.
TOOLS NEEDED
Tape Measure
Glass Board x 1
Tray Mount x 1
Phillips Tray Screw x 2
Aluminum Tray x 1
Board Hardware Kit
Marker Tray Hardware Kit
1/4", 5/16" and
1/8" Drill Bits
Power Drill
Wall Mount Bracket
Outer Cap x 8
Plastic Anchor x 8
Drywall Anchor x 8
CS Screw x 8
Wall Mount Bracket x 8
Two Person Assembly Required
Level
Chalkline
Stud Finder
Phillips
Screwdriver Bit
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
