background image

Ubee Interactive 

— www.ubeeinteractive.com 

 

 

 

  Ubee DVW325 

– Safety and Installation Product Insert v1.0 

DVW325 Advanced Wireless Voice 
Gateway - Safety and Installation 
Product Insert 

 

Federal Communications Commission 
(FCC) Interference Statement

 

This device has been tested and found to comply 
with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These 
limits are designed to provide reasonable 
protection against harmful interference in a 
residential installation. This device generates, 
uses, and can radiate radio frequency energy. If 
not installed and used in accordance with the 
instructions, the device may cause harmful 
interference to radio communications. There is 
no guarantee, however, that interference will not 
occur in a particular installation. If the DEVICE 
causes harmful interference to radio or television 
reception, which can be determined by turning it 
off and on, the user can try to correct the 
interference by one of the following measures: 

 

Increase the separation between the 
DEVICE and the equipment with which it is 
interfering (for example, a television or 
radio). 

 

Connect the DEVICE into an electrical 
outlet on a different circuit than the 
interfered device is connected. 

 

Consult the dealer or an experienced 
radio/TV technician for help. 

 

FCC Regulatory Information 

This device complies with Part 15 of the FCC 
Rules. Operation is subject to the following two 
conditions: (1) This device may not cause 
harmful interference, and (2) this device must 
accept any interference received, including 
interference that may cause undesired operation.   

There are two statements for this product: 

 

 

Only the type of Metal PIFA antenna tested 
may be used. 

Summary of Contents for DVW325








Reviews: