•
If the alarm has been modified, dismantled, contaminated, damaged,
neglected or otherwise abused or altered following the date of purchase,
•
If it fails to operate due to incorrect siting, installation or maintenance
•
Damage caused by failure to abide by the instructions supplied.
It is specifically drawn to the users attention that substantial periods in alarm will
shorten alarm life, during which time the fire alarm will have provided valuable
protection; no Claim under the guarantee will be entertained. The liability of
UltraFire, arising from the sale of this alarm or under the terms of this guarantee
shall not in any case exceed the cost of replacement of the alarm. In no case,
shall UltraFire be liable for consequential loss or damage resulting from the failure
of the alarm or the breach of this or any other guarantee, express or implied or for
damage caused by failure to abide by the instructions supplied.
This guarantee does not affect your statutory rights.
UltraFire
33 West Street, Alford, Lincolnshire, LN13 9FX, United Kingdom
Telephone: 0800 978 8262
Email: support@ultra-fire.co.uk
UltraFire
ULLS10RF 2797-CPR-749677
BS EN 14604:2005 KM 623822
10
Yea
r
Batter
y
L
ife
10
Year
Bat
ter
y
L
ife
6.
Screw the pattress to ceiling using the fixings provided. You may also use
two half-moon shaped and double sided fixing pads.
7.
Alternatively, you may use any proprietary builders fixing adhesive
normally used to fix skirting boards and other light building components
to walls etc.
NOTE: Be sparing with any adhesives used on the back of the radio pattress
to avoid excess adhesive squeezing through holes onto the circuit board.
When using adhesive pads or adhesives make sure the surfaces are flake
free, clean, dry and flat. Take care to use all appropriate Health and Safety
precautions when fixing the pattress and alarm to their surface - in particular
use appropriate access equipment, protect yourself from dust and wear eye
protection.
Do not change any components of the system for those made by other
manufacturers. Up to 15 alarms may be paired to the system.
WARNING: The electronic test button provides a full test of the alarms
functionality. Do not try to test the alarm using either heat smoke or naked
flame as damage will occur.
7. USER INFORMATION
Protect your Home Against Fire
Contact your local Fire Brigade for a home safety check, this information is free
and will identify potential fire hazards in and around your home.
Make sure all occupants of the home know what a fire alarm sounds like. Prove
and practise a fire escape plan and arrange a suitable and safe assembly point.
What to Do if the Alarms Sound
Alarms sounds are as follows:
Full alarm indicating
smoke and fire
Repeating series of 3 beeps every
4 seconds with flashing light
Low battery
Single beeps every minute
Test button jammed
One beep every 11 seconds
Fault
Double beep every minute
Ensure everyone leaves the building as soon as possible.
•
Do not run.
•
Do not stop to collect belongs.
•
If it is safe to do so, close all windows and doors as you escape to
prevent the spread of fire.
•
Smoke is the main cause of death from fire. If trapped inside the building,
cover your mouth, conserve breath and crawl to safety.
Do not silence a fire alarm until you know the cause of the alarm and when all
occupants are safely outside the building.
Silencing an alarm
Do not silence a smoke alarm until you are certain there is no fire. The fire
alarm that has detected a fire will be flashing its red light in the centre of the
test button once every second, all other alarms in the system will just be
sounding.
To silence the fire alarm system, press the test button on any alarm in that
system. If one alarm continues to sound, it will be the one that has detected
a fire. Check for a fire in its area and for its flashing red light. ONLY if you are
certain there is no fire, press its test button to silence it. If you are not certain,
evacuate the property and call your fire and rescue service on 999.
8. ALARM MAINTENANCE
A regular program of fire alarm maintenance will help to keep your alarm in good
working order.
•
Test the alarm weekly making sure that all interconnected alarms in the
system sound within 10 seconds.
•
Vacuum the alarms every six months and wipe them with a damp cloth.
•
Do not paint the alarm.
A smoke alarm is a sensitive life-saving device. The life of this alarm can
be significantly reduced by adverse environments, incorrect location and a
failure to regularly clean and maintain it according to the instructions. Incorrect
location and a lack of reasonable care may also cause it to malfunction and will
invalidate the warranty.
9. TROUBLESHOOTING
The battery in the alarm will last ten years and the battery in the pattress will last
ten years - they are both non-replaceable. At the end of its life the alarm will beep
once every minute for a minimum of one month. The life of the battery can be
significantly shortened by periods of storage or use in temperatures below 5°C or
above 30°C. It will also be shortened by frequent or extended periods in full alarm
often caused by conditions such as cigarette smoke, steam, aerosol spray and
condensation. In these circumstances the warranty will be void. If this happens
at night you can press the test button to silence the battery warning for 10 hours.
Replace the alarm as soon as possible.
Problems are indicated in five ways;
1.
The alarm beeps twice every minute indicating a malfunction.
2.
The alarm beeps once every minute indicating a low battery.
3.
The full alarm sounds for no reason. (A repeating series of three beeps with
flashing light)
4.
The alarm does not sound when pressing the test button.
5.
The test button light remains steadily on or off. (i.e. does not flash
approximately once every minute, when the unit is not in alarm) Inspect for
obvious damage. Check that the alarm has been installed in accordance
with the instructions. In the case of repeated nuisance alarms, check that
it is free from dust, cobwebs and external contamination from such things
as cigarette smoke, drying paint, spray from household aerosols and steam
that will ultimately shorten the life of the alarm and invalidate the warranty.
If this does not correct the problem, do NOT attempt to repair. There are no
user serviceable parts internally. If the smoke alarm is within the warranty
period and terms, indicate the nature of the problem and return the unit with
proof of purchase to the address at the end of this manual. Units beyond
warranty cannot be economically repaired.
10. PRODUCT WARRANTY
UltraFire guarantees to you, as a purchaser, that the enclosed fire alarm will
be free from defects in material, workmanship or design under normal use and
service for a period of 10 years. The enclosed Radio Pattress is guaranteed
for 10 years. These Guarantees are not assignable. Our liability to you, under
this guarantee is limited to repairing or replacing any part which we find to be
defective in material, workmanship or design, free of charge to the customer, upon
sending the alarm with proof of date of purchase, postage paid to
UltraFire, 33
West Street, Alford, Lincolnshire, LN13 9FX, United Kingdom
. The terms of this
guarantee will not apply in the following circumstances:
USER MANUAL
ULLS10RF OPTICAL SMOKE
ALARM WITH RADIO-INTERLINK
Optical Smoke
Alarm
Radio-Interlinked
DOC 1482 - V1.0
