NOTE: Your sensor has been preset by the manufacturer to the most commonly
used settings. It is recommended that users test the unit(s) under the default
settings beforem
aking adjustments. If you have questions about these settings,
please contact Customer Service.
Your Driveway Alarm System
Sun Shade
Detection PIR
Interval "sleep" Timer
7 seconds
Power Saving
Mode
OFF
Filter
3-6.5 ft (0.9~2m )/sec
Sensitivity
High
Powering Your Sensor
The sensor runs on four (4) AA batteries and operates wirelessly at a maximum distance
of 800m from the receiver.
1. Unscrew the four cover screws and remove the cover.
2. Install four (4) AA batteries as indicated.
3. Replace the cover and secure the four screws.
4. Attach the sun shade.
800m Wireless Driveway Alert
USER MANUAL
Advanced Settings: Sensor Adjustments
Several switches are inside the battery compartment which regulate various sensor
functions. Follow this guide to adjust your unit to the desired setting(s).
NOTE: Your unit is already set by the manufacturer to the most commonly used settings.
Only make adjustments to these settings if the unit does not work as desired under the
factory settings.
Remove the sun shade and the four screws holding the sensor cover in place.
Inside the sensor unit is a battery compartment and rows of switches which control the
sensor settings. Use the guide below to set the sensor according to your preferences
using a pen or other hard, narrow object to move the switches.
Sensitivity Jumpers
Power Saving Mode
Interval Sleep Time
Filter
Hidden Mode
Test
Button**
Sensitivity
Filter
3-6.5 ft/sec.
(faster movement)
(45~90cm /sec.)
(0.9 ~2m/sec.)
(slower movement)
High Mid Mid
Low
Power Saving Mode
Dusk till dawn
24 Hour
Interval “Sleep” Timer
*
7 sec.
30 sec.
High High
1.5-3 ft /sec.
The default sensitivity setting of the PIR is set to ‘High’, if you are detecting objects
that you do not want to detect, please try adjusting the ‘sensitivity jumpers between
Low, Low/Medium. Low/High by carefully moving the switch positions (as per
diagram).
The default setting for the Power Saving Mode is ‘OFF’ which gives you 24 hour
operation, for applications where it would be convenient for the PIR to only work in
low & dark light levels, please adjust ‘Power Saving Mode’ to ON. Ideal if you have
a location where you just want Alerts during the night.
This is the time that the PIR will be inactive after an activation, therefore 30
seconds will result in better battery life, 7 seconds will result in better protection.
This allows you to set the PIR up to detect slower or faster movement.
* After detecting motion, the sensor can “sleep” for either 7 or 30 seconds,
allowing ano
bject to pass through the field of vision before setting the alarm off
again.
** The Test Button can be pressed during set up to test that the sensor has been
correctly paired with its receiver. The Test Button is also used to recode the
sensor in cases where more than one receiver is being used (see Helpful Tip on
Page 3).
Page 4
Pencil Beam
Adaptor
Sun Shade:
To reduce the interference of the direct sun shine.
Detection PIR:
Passive Infrared Detection W indow
Narrow angle adaptor:
Remove this adaptor to make wider angle.
Pencil Beam Adaptor:
Replace narrow angle adaptor to create a pencil beam
Test button:
Press this button to test the transmitter
Battery compartment
Test button
Narrow angle
adaptor
Press and hold test button for 5 seconds, the LED indicator will blink 2 times to
indicate switched to the hidden mode. The LED indicator will not light after trigger
in hidden mode. Press and hold the test button 5 seconds again, the LED wil light 3
seconds to indicate exit the hidden mode.
