If for any reason the system should cease to
function, disconnect the unit immediately as a
safety precaution, then call 855-FISH-LIGHT.
DO NOT press the reset button on the
GFCI plug.
Warning!
Extend the Life of
Your System
Warning!
Your system should run continuously
each night for optimal results and
self-cleaning. A minimum of eight
hours per night is required to keep
growth off the bulb.
The bulbs must never be illuminated
out of the water. They run the risk of
overheating.
Wire shield is the best way to protect
against nicks in the wire caused by fish
hooks or other aquatic life. Nicks in the
wire are considered damage and not
covered under the three-year manu-
facture warranty. You can purchase
wire shield through our website.
Extend the Life of
Your System
Installation Instructions
1. Mount the control box on a post or
piling on or near your dock in a well
ventilated area within 10ft of your
power outlet and ideally 6ft above the
waterline. Be sure not to over-tighten
the screws.
2. Attach the weight securely with the
two zip ties a minimum of 1 inch away
from the base of the bulb.
3. Lower the weight into the water. The
bulb unit will follow. Be sure to handle
the bulb with caution.
4. If you have a multiple light
system, simply repeat steps 2 and 3
for remaining light assemblies.
5. Attach the photocell to the top of
the box, taking care to align the
prongs.
6. Plug the 10ft power cord with
the inline GFCI into an approved
GFCI outlet.
7. Wait for dark and enjoy!
Installation Instructions