PMI Evidence Tracker™
Procedures for using the Unitech Portable Data Terminal
Scan Button
“ENT” Enter Button
Power Button
“CMD” button
In order to begin using your Unitech HT630, all you need to do is turn on the unit. The unit has been pre-
programmed with both the Evidence.exe and the Asset.exe. You can turn on the power by pressing the red power button
as indicated in the above diagram. There is no specific unit configuration for this model.
Running a program
1. Turn on the unit by pressing the red power button.
2. Press and hold the CMD key for 2 seconds to get to the main menu.
3. Select 1. Run, then ENT.
4. Scroll by using the arrow keys to find the appropriate program, either EVIDENCE.EXE or ASSET.EXE. Elect ENT
to execute the program.
5. Once the program has started, you can begin your full audit.
Performing an Audit for Evidence
1. Turn on the unit by pressing the red power button.
2. Press and hold the CMD key for 2 seconds to get to the main menu.
3. Select 1. RUN, then ENT.
4. Scroll by using the arrow keys to find the EVIDENCE.EXE program. Elect ENT to execute the program.
