Part E
M6*10 bolts Qty. 2
Part F
bolt covers Qty. 2
Part D
Allen wrench (small)
Part C
Allen wrench (large)
© UPLIFT Desk
• 1-800-349-3839 • info@upliftdesk.com • www.upliftdesk.com
®
UPLIFT Adapt Freestand
™
Instructions
UDA100~freestand
Step 2
Line up the holes on the plate of the keyboard tray (Part B) with the
holes on the vertical connector under the main assembly’s work sur-
face.
Attach keyboard tray to the main assembly using two M6*10 bolts
(Part E) and tighten using the small Allen wrench (Part D).
Cover the bolts with the adhesive bolt covers (Part F) by centering
the sticky side on the heads of the exposed bolts as shown in diagram.
Adhere the pad around the bolt by pressing all around the bolt.
Step 1
Press and hold the release paddle in the up position on the UPLIFT
Adapt main assembly (Part A) to raise the worksurface to the highest
position. Release the paddle to lock in place.
Part B
keyboard tray
Part A
Adapt Freestand
main assembly
Step 3
Adjust the height of the unit by squeezing the release paddle
and moving to desired position.
