SuperCapacitor Vehicle Video Recorder
Please contact your local dealer if you have any question on this product.
Installation Guide
(1) This device should be installed in the area where
the windshield will be able to be cleaned.
(2) Formatting SD card on the device before beginning
to use.
(3) Set time zone and timing on OSD, or
auto-calibrating by GPS.
(4) NTSC or PAL setting through OSD.
(5) Electricity consumption: 500mA. If power supplied
by PC, please use Y Type USB Cable.
3. Adjust the view angle
properly.
4. Plug in the DC5V
power supply.
5. Plug in the cigarette
charger.
6. VVR Installation.
Best location
Cigar lighter
3M sticker
1. Power on / Record
Turn on device and wait for around 20 sec ready
for recorded.
2. Power off / Stop record
After power off, wait for superconductor’s supply
is off, when the power are all off. Take out SD card
for backup or format.
Remote Controller
Check the mercury cell is installed in
correct direction. (Check the pole)
Check if the cell power is exhaust.
Check if the sensor is covered.
Check if it nears by Fluorescent Lamp.
How to check if the remote
controller is workable?
Emergency
REC
Play
Menu
Navigator
Enter
Stop
VACRON Player
OSD
screen
on / off
Please go to VACRON Website to
download vacron viewer
*Reminder- DirectX 9.0 is required.
Recording & Stop Recording
Product Diagram
Safety Precautions
Please Take and review some testing videos initially to make sure the images were recorded correctly.
Please note that manufacturer, its subsidiaries and affiliates, and its distributors are not liable for
consequential damages arising from any malfunction of main device accessory, including memory
device that results in the failure of an image to be recorded or to be recorded in a way that is machine
readable.
Before using the product, please ensure that you read the safety precautions described below. Always
ensure that the product is used correctly.
• Use only recommended power sources.
• Do not attempt to disassemble, alter or apply heat to the product.
• DO not apply multi cigarette lighter adapters-Applying such devices will cause
unstable power input to damage the vehicle video recorder.
• Please always make sure all power connectors are fully secured.
• Avoid dropping or subjecting the product to severe impacts.
• To avoid the risk of injury, do not touch the interior of the product if it has been
dropped or otherwise damaged.
• Stop using the product immediately if it emits smoke, a strange smell, or otherwise
behaves abnormally.
• Do not use organic solvents such as alcohol, benzene, or thinner to clean the product.
• Do not let the product come into contact with water (e.g. sea water) or other liquids.
• Do not allow liquids or foreign objects to enter the VVR.
• Do not place the VVR near or in direct flame.
• Do not handle the power cord with wet hands.
• Do not use the equipment in a manner that exceeds the rated capacity of the
electrical outlet or wiring accessories.
• Do not use if the power cord or plug are damaged, or not fully plugged into the outlet.
• Do not allow dirt or metal objects (such as pins or keys) to contact the terminals or plug.
• Avoid using, placing or storing the product in the humid or dusty areas.
For More Information
Please check VACRON Website
http://www.vacron.com
Made in Taiwan
Copyright@ FUHO Technology CO., LTD.
2017 MAY. V1.0
H11A0N3700
3"
-10
℃
~45
℃
120º
100º
CH1 / 1080P
Google Map
CH2
OPTIONAL
External Camera (optional)
Installation diagram
To stall External Camera with 4P Phone Jack Connect (1 Vp-p Composite
Video Output) in front or rear of the car.
Definition of 4P Phone Jack connect
Negative
Signals
Positive
Note: To avoid camera damage, please power
off the vehicle video recorder before plug the
camera in.
1. Select suction-cups or stick-holder type bracket.
Notice
2. Find the optimal position
of device on the
windshield.
SD Card Installation
OSD Menu
Notice
Screen Spilt
Sleep mode
Time Setup
G-sensor
MIC ON/OFF
Format SD card
Restore
Version
1.Open SD card cover
on the device to insert
of remove SD card.
2.When not using SD
card, please close the
cover to avoid dust or
other items get into
device.
(1). Recommend Memory Card class 10
or above (Minimum of 8GB)
(2). If SD card did not format by Player
before using, device will delete all
data inside and format it automatically (take
1~5mins). After it’s done will start to record.
(3). Please do not convert Micro SD to SD card to
begin recording, to avoid the damage during
recording.
(4). Since memory cards have the writing
endurance situation, we recommend to
inspect the memory card and use pc for
playback regularly, to ensure that the memory
card can read and write.
(5). Some brand of SD card might not suit for
device, if it is not working please change other
brand SD card or Class.
(6). If SD card did not format by player, device will
delete all data and setup atomically. Some
devices will not able to recorded if SD card is
not format.
(7). SD card 8G、16G、32G、64G or 128G, after
format by Player. The space will only show up
for 80MB rest of memory space will be
displayed by Player only.
(8). Please backup data from SD card regularly.
Avoid losing data.
(9). When event happened, please take SD card
out and lock it. To avoid overwrite.
3.SD card Format / SD card Restore.
1. 5V cigarette Power adapter (miniUSB 3.5M)
2. PHONE JACK 4 ports 90 deg turn to micro din with extra wire 2.5M
3. Remote controller
4. Product Disc
5. Suction cup bracket
6. Bracket holder
7. Quick user guide
Standard
Optional
1. 8G/16G/32G/64G/128G _Class 10 SD card
2. External GPS Mouse(4P Phone Jack Connect)
3. External 720P (AHD Interface)
4. Extra wire for MIC(4P Phone Jack Connect)
External Camera (optional)
TYPE A : Built-in GPS
TYPE B : External GPS (optional for G-mouse)
TYPE C : W/O GPS
CH2 External
camera plug
Monitor On/Off
GPS positioning
Green light: power
Red light: recording
Red light(fast flashing)
：
Enforced recording
LCD 3
＂
16:9
SD card Slot
CH1 1080P Lens
RTC battery cover
DC5V power input
Mini USB
FOR PC
AV output/
GPS Mouse extra slot(optional)/
Extra wire for MIC(optional )
