Valcom VIP-814, User Manual

1                                                                                       947997 

CAUTION:  To reduce the risk of electric shock,

Do not remove cover.

No user serviceable parts inside.

Refer servicing to qualified service personnel.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.

This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.

ISSUE 6

VIP-814 

QUAD NETWORKED STATION PORT 

INTRODUCTION

The VIP-814 Quad Networked Station Port 
allows most loop start terminal devices to be 
connected to a managed IP-based LAN/WAN.  

SPECIFICATIONS 

Access Methods



PBX, FXO Port  



POTS telephone set 

Features



RJ-45 for network connection 



4 RJ-11 telephone connections 



4 Relays with Form C contacts 



Generates Caller ID Signals 



Front panel Status/Link/Activity LEDs 



 2 

REN 



2.5mm jack for external power (optional)  



Power over Ethernet 802.3af compatible 

Dimensions/Weight 



1.75 H x 6.75" W x 9.5" D  
(4.45cm H x 17.15cm W x 24.13cm D) 



Weight:   1.75 lbs.  (0.80 kg) 

Nominal Specifications

Input Impedance: 

600 Ohms 

Input Level: 

-10dBm 

Output Impedance: 

600 Ohms 

Output Level: 

- 10dBm nominal  

Relay Current: 

1 AMP @ 24VDC 

Nominal Power Requirements 

Via rear panel barrel connector: 

Voltage: 

24VDC 

Current: 

 325mA  

Via 802.3af PoE Ethernet Switch: 

802.3af:    Class 

3 

Environment

Temperature:                                   0 to +40° C 
Humidity:     

          0 to 85% non-precipitating

 
 
Packing List

Qty

Item 

1 VIP-814 
1 VSP 

Document 

2 

Mounting Brackets W/ Hardware 

4 Rubber 

Pads 

INSTALLATION 

NOTE:  The telephone system referred to in 
this manual is the customer premise 
equipment such as an electronic key system, 
a PBX or a dedicated single line telephone 
sets.  The VIP-814 is not intended for direct 
or indirect connection to the public 
telephone network.  When used with a 
customer premise telephone system such as 
a key system or PBX system, these units are 
interfaced to the system via a fully protected 
page port or system central office port, 
which is a fully protected interface device.  
Also, the host system must be configured to 
disallow central office trunk conferencing in 
order to prevent indirect connection to the 
public network. 

Precautionary Designations