Fitting Instructions - Read instructions carefully before fitting and follow them for correct use
IN8176
Bulkhead - VG273 / VG298
This FITTING INSTRUCTION is the property of VAN GUARD ACCESSORIES LTD. and must not be used for
manufacturing purposes, copied nor communicated in any way to third parties without written
permission from VAN GUARD ACCESSORIES LTD.
IN8176_B
Van Guard Accessories Ltd
Fair Oak Close, Exeter Airport Business Park,
Exeter, Devon, EX5 2UL
www.van-guard.co.uk
IN8176 - PAGE 1 OF 3
!
??
DRILL (Ø4.5MM) X1
SPANNER (10MM) X1
PH SCREW DRIVER X1
1. You should note that it is the responsibility of the installer/s to ensure that when drilling holes in to your
vehicle to take fixings, care must be taken to ensure that the fuel line, tyres, fuel tank, wiring loom, exhaust,
bodywork and brake lines etc. are not damaged. Whilst every effort has been made to ensure our products can
be safely fitted, changes to vehicles sometimes occur so it’s always necessary to check before drilling.
If in doubt refer to the vehicle manufacturer’s dealership.
2. When drilling, use as short a drill bit as possible to prevent damage to the vehicle. Use corrosion protection
when drilling the vehicle.
3. Wear the appropriate protective equipment (safety glasses & gloves) while fitting this product.
4. Regularly inspect all fixings and parts. Any damaged or worn parts should be immediately removed the
vehicle and replaced.
5. Retain instructions for future use. It is important that the end user receives this document.
TOOLS REQUIRED
ME0312
X1
(SIDE - RIGHT)
ME0313
X1
(SIDE - LEFT)
ME0311
X1
(FIXING PLATE)
FX4012
X2
(M6X16)
VG273S / VG273P =
ME0310
X1
VG298S / VG298P =
AS3298
X1
(BOTTOM)
VG273S / VG298S =
AS3291
X1
VG273P / VG298P =
AS3292
X1
(TOP)
FX4013
X2
(M6)
FX4016
X16
(M6)
FX4018
X2
(M8X20)
FX4020
X18
(M8)
FX4086
X2
(No14 x 1.5”)
SPANNER (13MM) X1
FX4087
X4
(No14 x 1/2”)
FX4042
X16
(M6X16)
CAUTION - IMPORTANT NOTES
