Installation Guide
Enclosure for 2.5” 7/9.5mm SATA 6Gbps SSD/HDD
Copyright © 2016 Vantec Thermal Technologies. All Right Reserved. | All Registered Trademarks Belong To Their Respective Companies.
Information in this document is subject to change without notice.
Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden.
Printed in China
Printed on Recycled Paper.
v1.01
NST-228S3-BK
www.vantecusa.com
4. Insert the hard drive caddy back into the NexStar
TX housing as the picture show. Be sure to align
the caddy with the guides within the housing.
3. Carefully connect the 2.5” hard drive to the
connector.
2. Parts Layout.
SATA/Power Connector
USB 3.0
LED
1. Verify the package contents.
USB Cable
5. Secure the caddy to the housing using the screws
provided.
USB Cable
6. Connect the USB cable. (Power will be drawn
from the USB port and provide power to the
hard drive)
7A. If you install a new drive, proceed with the
necessary setup procedure to initialize, partition
and format the new hard drive using the OS tool.
7B. If you install a drive with exsiting data, you
should be able to use the OS file manager to
see your data.
tape rubber
here to
cushion
drive when
inserted
Peel off white
tape
,
secure the translucent
plastic sheet on the
printed circuit side of
the hard drive.
