background image

Care Instructions - 

Read Before Installation

- This box contains fragile and valuable goods that 
have been carefully packed. Please take utmost care 
in unpacking the parcel as damage can occur in this 
process.
- Please be sure you have received the correct 
number of boxes i.e. 1 of 2, 2 of 2 etc.
- Under no circumstances should the product be 
lifted out by the neck or light fitting.
- If you have received any damaged goods or are 
missing any part of your order, please contact our 
sales office as soon as possible

Recycling

- Recyclable packaging used, please consult with 
your local recycling centre for further information.
- Waste electrical products should not be disposed 
of with conventional household waste. Please 
recycle all parts when possible.

Cleaning Instructions

Brass 

- all types:  Use a soft dry lint free cloth

Bronze, Nickel, Silver & Chrome: 

Use a dry cloth only, 

no chemical cleaners

Glass: 

We recommend using a strong alcohol such as 

isopropyl alcohol. Note: some modern cleaning 
solutions can contain chemicals that can leave a 
greasy film on glass.

Gilt Wood: 

Use a dry cloth only

Ceramic:

 Use a damp cloth only

Wood: 

Wax polish i.e. Antique wax

Alabaster:

 Dust with a soft brush or a clean dry cloth. 

Avoid water or water-based cleaners. Any marks that 
cannot be removed by dusting must be cleaned by a 
specialist.

Lacquered Furniture: 

Furniture polish

Crystal: 

Damp cloth

Card/Laminated Shades: 

Use a Feather duster only

Silk Shades: 

Gently tap to lift dust

Needlework:

 Dry-clean

-Any decorative parts made from other materials 
must be removed and cleaned separately to avoid 
damage - e.g. alabaster. 

After choosing a suitable location that meets all the requirements of 

the safety information install the unit following the steps overleaf.

 

- Carefully unpack all parts and check for damage or missing parts 

before commencing installation.

- Installation of this product must be carried out by a qualified 

electrician.

- Luminaire is for indoor use only

- Disconnect the electrical supply before installation. Switch off the 

electricity at the fuse box by removing the relevant fuse or switching 

off the circuit breaker before proceeding with the installation.

- Install should be carried out in accordance with the wiring regulations 

and building codes applicable to the country of installation.

- Before making any fixing hole(s), check that there are no obstructions hidden beneath the mounting surface 

such as pipes or cables.

- Ensure that the support for the light is of sufficient structural strength and that any fixing screws do not 

interfere with the connecting cables.

- The unit can get very hot during use. Switch the product off and allow to cool before handling or changing 

bulbs.

- Ensure adequate ventilation space is allowed between the unit and any object above, in front or to either 

side of the unit. Suggested minimum space is 0.5m above and 0.5m on all sides.

- To prevent tarnishing, it is advisable to wear gloves at all times when handling the product.

- Mains connector must be a lever slicing connector; with a minimum of 3 terminals; rated to 240v 16A 

(minimum); conforming to IEC 60998-2-1 or IEC 60998-2-2.

Safety Information  - Read Before Installation

VAUGHAN 

Installation Guide 

www.vaughandesigns.com

Chartwell Wall Light

WA0017

Rev 1

Reviews: