VIDEX VproX-100
(2 DOOR, 100 KEY SYSTEM)
1
DESCRIPTION
The
Vprox
100
is an advanced access control system based upon the VIDEX unique
Coded Key giving over 4 billion combinations. The system will operate and control two
independent doors and store up to 100 contact keys or proximity Tag or Card, each door
can also have an additional reader. Connections from the reader to the control equipment
can be made using un-shielded 5 core cable up to a distance of 200 meters, or a
maximum resistance of 10 Ohms.
Push to exit switches at each door will operate the associated relay in the control unit for
the programmed entry/exit time.
Security against sabotage, is maintained by having the VproX control equipment remote
from the reader heads. Should un-stored or un-qualified keys attempt to operate the
system, the control unit will disable all readers after every 5 attempts, the duration of the
readers disable time will increase if further attempts are made.
The control equipment has an LED display that confirms all data in programming mode,
and displays the key number when in the stand by mode
(when key inserted).
The system has 4 push buttons for programming and modifying the information. Using
these buttons it is possible to :
Program a Master code to access the programming menu.
Program up to 100 unique keys or Tags with door access options.
To modify the settings and parameters of a stored key.
Delete one or more keys or Tags.
Program each door relay time
(1 to 99 seconds)
INITIALISATION
When the installation has been completed
(carried out in accordance with the supplied
wiring diagram)
, the system can be powered up and programmed following the VproX
100 Programming FLOW CHART, on completion the VproX 100 is ready for use.
NOTE:
we suggest to separate the Mains lines
(lift, electricity, electric lock, etc.)
from
the readers connection line
(at least 10 cm. far or use shielded cable for it)
to avoid
electrostatic discharge and magnetic influence which could give control problems to
the CPUs present on the system.
OPERATION
In stand by mode the DISPLAY shows “--”, when a stored key is inserted at any of the
reader heads the display will show the key number and which door is being operated
(decimal point position). When a stored key is inserted at any of the readers, the readers
LED’s will display green and a sharp “beep” will be emitted. If the key is not
programmed the Display will show nothing and the readers LED’s will display Red and a
low “beep” will be emitted
To operate relay 1 for the programmed time
(door open)
a n/o switch or short across
terminal “S1” to ground is required.
To operate relay 2 for the programmed time
(door open)
a n/o switch or short across
terminal “S2” to ground is required.
VP100
