Viglen Getting Started Guide
Genie Ultra Micro
Included fittings
If you purchased your Genie Ultra Micro from Viglen, the fitting lugs (2x screw A) will already be in place.
Otherwise you will need to fit the lugs shown below.
1
2
3
4
1
2
3
4
Step 1
Mounting the cable cover
u
Ensure that screws A are fitted
to chassis. Align the chassis
onto the monitor stand and slot
into place.
u
Slot the chassis down into the
slots marked 2 to lock into
place (
figure 1
).
u
Turn the retaining clips to
secure the chassis and lock the
chassis using optional screws B
provided through the low holes
on the retaining clips (
figure 2
).
Step 2
Attach the chassis to the stand
u
Ensure that screws C are fitted
to the two bottom monitor VESA
points (
figure 1
). Align the rear
VESA mount of the monitor with
the VESA bracket on the
monitor stand.
u
Ensure the monitor is now
slotted in place on the VESA
plate (
figure 2
).
u
Hold the monitor in place and
secure it using the screws D
provided to the upper holes
(
figure 3
).
Step 3
Securing the monitor to the stand
6
Screw A
Screw B
Screw C
Screw D
Cable Cover Block
( x 2 )
( x 2 )
( x 2 )
( x 2 )
( x 1 )
Screw A
6
Tools required
Cross-head screwdriver
Additional parts
Depending on the configuration you purchased,
you may also receive the following items:
u
Internal Speaker (mounted in the Cable Cover)
u
Split Mains Power Cable for the base unit and monitor
(includes a converter for the AC adapter)
Start Guide - Genie Ultra Micro (2009-06)
5
5
Screw B
Screw C
Screw D
u
Feed all cables through the aperture in the bottom of the
cable cover and attach them to the ports on the
motherboard, including the cables from the optional
monitor stand and optional internal speaker.
u
Slide the AC Adapter into the cable cover and insert the
retaining block (
figure 1 and 2
).
u
Attach the power connector to the power socket at the
rear of the chassis (
figure 3
).
u
Attach the cable cover on to the Genie Ultra Micro
chassis by engaging its lugs in the corresponding holes at
the rear of the chassis and slide down firmly until you
hear it clip into place.
u
An optional Kensington-style locking device can be used
to lock the cable cover in place.
1
2
3
1
2
3
1
2
Contents
Monitor stand
Genie Ultra Micro chassis
Cable cover
(optional)
(optional)
Monitor
Power Adapter
Fittings (see ‘included
(optional)
fittings’ below)
1
2
