background image

PRODUCT MANUAL

Designed, Manufactured and Supported in the USA

C O M M U N I C A T I O N   &   S E C U R I T Y   S O L U T I O N S

Voice Alarm Dialing or Store Caster

Announcements from up to Eight Inputs

Features

Viking’s 

K-2000-DVA

is a fully programmable

multi-input, multi-number auto dialer and digital
announcer, designed for emergency and non-
emergency message notification. The 

K-2000-

DVA

has eight dry contact inputs, each of which

can dial up to eight 32-digit phone numbers and
play a message up to 1 minute in length specific
to that input.

Messages can be recorded locally or remotely with
a total message time for all 8 inputs of eight
minutes.  When configured as an alarm dialer, the

K-2000-DVA

has call progress detection capability

with normal and fast busy, call pickup, CPC and
ring-no-answer detection. The 

K-2000-DVA

can

also be set up as a store caster (no dialing), for on-
site promotional or assistance announcements.

•  Non-volatile memory (no batteries required)
•  Stores up to eight 32-digit phone numbers per

input  (sixty-four 32-digit numbers total)

•  8 minutes of record time (1 minute per input)
•  Programmable message repeat counter
•  Programmable lap counter 
•  Eight inputs programmable normally open or

normally  closed and enabled or disabled

•  Programmable ring delay for remote

programming and alarm polling

•  Programmable qualifier timer for each input

(time for an event to be qualified as an alarm)

•  Programmable resume timer for each input

(time following reset for input to become active again)

•  Call progress detection
•  Programmable ringback limit for call progress
•  Remote security and access codes
•  Store caster mode
•  Local or remote programming and recording
•  RS-232 port for programming via a PC
•  Compatible with the Viking 

RC-2A

and 

RC-3

remote DTMF controllers

•  Phone numbers may be programmed as pager

numbers (no voice message played)

•  Programmable hookswitch flash before dialing

•  Line level input for loading pre-recorded

messages into the unit

Alarm Dialer

•  Security/burglar/fire alarm notification
•  System alarm or equipment malfunction notification
•  Environmental warning notification
•  Contacting personnel via numeric pagers

Store Caster

•  Provide assistance or promotional announcements in 

department stores, grocery stores, hardware stores, 
gas stations, etc.  ie: 

“Customer assistance needed 

in aisle 13...”

Power:

120V AC/12V DC 500 mA, UL listed adapter

provided

Dimensions:

8.3” x 6.3” x 1.8” (211mm x 160mm x 46mm)

Shipping Weight:

1.02 Kg (2.25 lbs)

Environmental:

0°C to 32°C (32°F to 90°F) with 5% to

95% non-condensing humidity

Talk Battery:

12V DC

Touch Tone Dialing: 

120 ms on/off, 50 ms on/off

CPC Detection Time: 

320 ms minimum

Message Record Time:

8 minutes

Sampling Rate:

64 K (equivalent)

Input Detection Time:

80ms with Qualifier Timer set to 0

Resolution Qualifier Timer: 

1 second to 18 hours

Resolution Resume Timer:

1 second to 18 hours

Connections:

(1) RJ11 jack for telco connection, (2)

3.5mm jacks for 600-ohm audio output and record in, (1)
9 pin RS-232 for PC connection, (1) 13 position screw
terminal block for inputs

K-2000-DVA

Multi-Input Voice

Dialer/Announcer

August 26, 2015

Applications

Specifications

VIKING

Programming can be done with a touch tone
phone or using a PC with a serial port connection
and free software available on the Viking website:

www.vikingelectronics.com

Summary of Contents for K-2000-DVA









Reviews: