VISION FITNESS T7200 Treadmill w/4.0
Console Engineering Mode Guide
1.
Enter engineering mode.
•
With the power to the treadmill on, press and hold down the
UP
↑↑↑↑
arrow elevation key and the
SLOW
↓↓↓↓
speed
key for about 5 seconds.
•
The safety key does not need to be removed.
Once in engineering mode the display should read.
SPEED WINDOW PROGRAM WINDOW FUNCTION WINDOW
4.0
P0
000
2.
Default values
Once you have reached this point, press the stop key to set the values to the default. Key must beep.
3. To set speed values
NOTE: Whenever setting speed values you must always enter both minimum & maximum speed.
Set minimum speed value
First you must use the DOWN
↓
elevation key to reach the P0 address. The display should look like this.
SPEED WINDOW
PROGRAM WINDOW FUNCTION WINDOW
4.0 P0
036 - 038
Adjust the speed of the treadmill to 0.5 mph by pressing the FAST
↑
or SLOW
↓
keys. The right function
window should read 036 - 038 for 0.5 mph. You can check this by counting belt revolutions 0.5mhp = 5
belt revolutions in one minute.
Press the SELECT key to store the lower data point. Key must
BEEP.
Set maximum speed value
Press the UP
↑
elevation arrow key, the display should read.
SPEED WINDOW
PROGRAM WINDOW FUNCTION WINDOW
4.0 P1 25D
If you have a speed wheel adjust the speed of the treadmill to 10.0 mph by pressing the FAST
↑
or SLOW
↓
keys. If you do not have a speed wheel, the right function window should read 25D.
NOTE:
This will be an average speed for 10 mph. If you have a speed wheel to count belt speed, you may
have to go outside the recommended settings.
Press the SELECT key to store the upper data point. Key must
BEEP
.
NOTE:
If you do not need to change elevation values, go directly to step 5 to save your new input values.
You always must do this step.
