Quick Guide
www.visiondrive.co.kr
Installation
Connect the attachment bracket with the main unit and push it
to the direction 1 to secure the lock to hear the click sound.
Connect the jack of option camera to the “CAM” port of the main
unit. (When connected to the main unit while the main unit is on,
the system will reboot to register the option camera and initialize
2 channel recording mode.)
Clean the area on the windshield where the unit will be installed.
For the placement of the unit, it is better to place the unit closer
to the center of the vehicle.
Insert the cigarette jack into an appropriate outlet then turn
on the engine.
The REC lamp is blue when it is recording. It is blue when it is
recording a (NORMAL) file and red when recording an (EVENT) file after
an impact or if the SHOT button has been pressed.
The GPS lamp is red when the GPS signal is not received and blue when
it is received. The GPS connection may take a couple of seconds to
several minutes, depending on the location of your vehicle.
Move the camera top to bottom to fix it to a recordable position
while checking the LCD
Connect the bracket and the unit
Connect the external option camera and
the main unit.
Insert SD card into the unit
Connect cable and attach on windshield
Connect to power source to turn
on the unit
Check LED lamps
Adjust the camera angle
Use the enclosed wire holders to organize the cable line..
Arranging wires
CAR BLACK BOX
Do not disassemble or remodel this product as it can cause an electric shock.
Only use adaptors with the appropriate specifications.
When installing the device to your vehicle, follow all the procedures and make
sure the mount is secure.
Unclean surfaces will weaken the adhesive strength and can damage the
product if it drops due to weak adhesion.
This product is not waterproof. Do not allow liquids and impurities to enter
the product.
Where the product is wired to the power supply of the vehicle directly or if the
cigar jack is connected to the power supply while the engine is off, make sure
to disconnect the device or set the battery monitoring function in the
configuration to prevent battery drain on your vehicle.
Do not use chemicals or detergents to clean the device. This can result in
malfunctioning of the product.
Installation & Use
Caution
1
2
Ver. VD-7000W 1.0E
2011. 01.
01 12:00:00
®
