VIZIT-ML
0-40
VIZIT-ML
0-40
VIZIT-ML
0-40
240
.
2.3
2
3
24
OPERATING INSTRUCTION
24
24
has degaussing module sealed together with electromagnet coil.
SPECIFICATIONS
VDC
9 … 15
kg
W
7 2
mm
kg
OPERATING CONDITIONS
-40C
+45C
98%
25C
PARTS LIST
SAFETY INSTRUCTIONS
15 VDC
INSTALLATION
ATTENTION:
1- .
Electromagnetic lock
is intended for locking doors (30 to 50 mm thick) in access control
systems. The lock is mounted inside the building on a door opening outwards. The lock should be used together
with a door closer.
Operating voltage,
:
Holding force,
(U=12V):
Power consumption,
(U=12V):
Dimensions,
:
Weight,
:
Ambient temperature range:
up to
Relative humidity of air:
up to
at
.
The lock does not contain voltage above
.
Do not make any connections or repair when the power is on.
Handle the equipment with care. Damage of the mating surface of magnet or armature plate may
reduce locking efficiency.
The lock should be installed inside the building according to directions on Figures
The armature plate is to be fixed on the door. The electromagnet is to be fixed on the door frame opposite to the
armature plate. Electromagnet work surface is shown on Figure .
To ensure maximum holding force the armature plate should be fixed close to the door edge considering
electromagnet installation.
For qualified installation, wiring and servicing refer to technical and commercial partners of VIZIT TM. The list
of companies is given on VIZIT.EU (
.
http://vizit.eu/eurounion/)
Electromagnet
Armature Plate
Mounting Kit (angle bar 40х40
)
x4 mm
Mounting Kit (for armature plate mounting)
Package
Operating instruction
1
1
1
1
1
1
Lock parts
Electromagnet
Armature plate
Width
Height
Depth
186
45
30
126
45
12
www.
24
201 -
Operating Instruction VIZIT-ML
0-40 (revision
5 10)
vizit.eu
1 3
/
