SF-1102 / SF-1102 T
The Connector SF-1102/SF-1102 T is classed as a Personal Protective Equipment (PPE) by the European Regulation 2016/425 and has been shown to comply with this
Regulation through the Harmonized European Standard BS EN 362:2004.
VIRAJ SYNTEX PVT. LTD., Factory / Office : C-36, UPSIDC Industrial Area, Rooma, Kanpur - 209402 (UP) INDIA
Ph.
Web :
, E-mail :
:
+91 9839505969, 9839803488, 9839811500, 9839601191
www.vsplgroup.com
ruchi@vsplgroup.com
GEPTESZT Kft. - Budapest Gyenes u. 12. 1032, Hungary, Contact No:- +36 1250 3531
IDENTIFICATION NO. CE 2233
Applicable to Connector
Manufacturer
Certification Body
2233
This Lanyard is designed to minimize the risk of/provide protection against the danger of falling from heights.
However, always remember that no item of PPE can provide full protection
and care must always be taken while carrying out the risk relation activity.
EU declaration of conformity can be accessed on www.vsplgroup.com
.
SF-1102 / SF-1102 T
SF-1102
SF-1102 T
USE AND PRECAUTIONS:
The connector is a piece of personal protection equipment, it should be allocated to a single user (it can only be used by one person at a time).
A connector is used for connecting two or more components of a fall arrest system. Generally, all components have attachment elements, which can
facilitate easy connection to the other component.
A connector can also be used as a fixed termination in a lanyard or energy absorber.
For connector without self-closing and manual locking gate, it is recommended that they should only be used where the user does not have to attach
and remove the connector frequently.
A connector should never be loaded across its gate.
Screw link (class Q) connectors should only be used where connections are infrequent. Screw link connectors are only safe for use when the screw
motion gate is fully closed. Ensure this by tightening them to the last possible point.
The length of connector should be taken into account when used in a fall arrest system.
Avoid situation that may reduce the strength of connector, e.g. connecting to wide strap.
Special features:
A connector is designed to minimize the risk and the danger of falling from height. However, always remember that no item of PPE can provide full
protection and care must always be taken while carrying out the risk related activity. The anchorage point of the fall arrest system should be situated
above the user (R>12kN - EN795:2012 or R>10kN - EN795:1996).
Product markings should be checked periodically for legibility.
The equipment should be connected to an anchoring point (R>12kN - EN795:2012 or R>10kN - EN795:1996). Check that work can be carried out so as
to limit the pendulum effect, the risk and height of a fall. For safety reasons before each use, make sure that no obstacle can prevent the device
unwinding normally in the event of a fall (free space under the user’s feet).
Before and during use, we recommend that you take every precaution necessary for an eventual safe rescue.
Pay attention to risks which can reduce the performance of your equipment, and therefore the safety of the user, if it is exposed to extreme
temperatures (<-30 ° C or> 50 ° C), prolonged climatic exposure (UV , humidity), to chemical reagents, to electrical conductivity, to trailing or looping of
fall arrest system to sharp edges, abrasion or cuts,.......
This equipment is for the sole use of people trained, skilled and in good health, or under the supervision of a trained and skilled person. Warning!
Certain medical conditions may affect user safety; if in doubt, consult your doctor.
