08/10/14
32II470e.B
1 of 5
INSTALLATION INSTRUCTIONS, KIT #55914
S/K SERIES LIFTS – PCB RI55664
Read and understand supplemental instructions completely before any work is attempted. Refer to the
Service/Owner Manual for additional safety precautions.
Check contents of this kit and notify Ricon immediately of any missing parts. Claims for damages that have occurred
during shipping must be made to the shipper.
TABLE OF CONTENTS
PAGE
I. PARTS
LIST
.................................................................................................................................................................... 1
II. TOOLS
REQUIRED
......................................................................................................................................................... 1
III. INTRODUCTION
............................................................................................................................................................. 2
A. REMOVE
FACTORY PCB ........................................................................................................................................ 2
IV. INSTALLATION
OF KIT #55914 ..................................................................................................................................... 2
A. INSTALLATION
OF PCB ASSEMBLY ...................................................................................................................... 2
B. INSTALLATION OF EXTENSION HARNESS, J2 .................................................................................................... 4
C. FINAL
INSTALLATION ............................................................................................................................................. 5
Under no circumstances is maintenance, repair, or adjustment of the R2000 Power Seat Base to be performed
without the presence of an individual capable of giving aid.
Give immediate attention to all injuries, and administer first-aid, or seek medical attention as necessary.
Protective eye shields and clothing should be worn during maintenance, repair, and adjustment of the R2000 Power
Seat Base.
Work in a properly ventilated area.
Check for hidden obstructions before drilling and cutting. Avoid interference with wiring, fuel tank, fuel lines, hydraulic
lines, subfloor members, etc.
Read and understand all instructions before attempting to operate the S/K Series Lift.
Read and understand all instructions before attempting to perform maintenance, repairs, or adjustments to the S/K
Series Lift.
Read and comply with warning labels attached to the S/K Series Lift.
I. PARTS
LIST
55664, PC BOARD ASSY. w/TWS,FOUR SENSORS
55913, HARNESS, JUMPER, EXTENSION
II. TOOLS
REQUIRED
PHILLIPS
SCREW
DRIVER
WIRE
CUTTER
WIRE
STRIPPER
WIRE
CRIMPER
3/8” DRIVE RATCHET HANDLE
9/16” SOCKET, 3/8” DRIVE
1/2" SOCKET, 3/8” DRIVE
