INSTALLATION INSTRUCTION
InvisiLED Tunable White
T24-TW3
Waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program
. OCT. 2022
1.
SAFETY INSTRUCTION
IMPORTANT: NEVER attempt any work without shutting off the electricity.
•
Always turn off power at fuse box prior to installation to prevent electrical shock.
•
Intended for indoor use. Dry and damp locations.
•
Install in accordance with national electric code, and local regulations.
•
Consult with local inspector to assure compliance.
•
Do not submerge or install within 5 feet of a swimming pool.
•
Do not connect the tape directly to high voltage power
CAUTION – TO REDUCE RISK OF FIRE AND ELECTRICAL SHOCK
•
Read all instructions before installing.
•
Handle product with care.
•
Do not conceal or extend exposed conductors through a building wall
•
To reduce the risk of fire and burns, do not install this lighting system where the exposed bare conductors can be shorted or contact any
conductive materials
•
To reduce the risk of overheating and potential fire risk, make sure all connections are tight.
•
Do not install any fixture assembly closer than 6 in. from any curtain, or similar combustible material.
•
Do not modify or disassemble product beyond instructions or warranty will be void.
•
Failure to follow safety warnings, and installation instruction will void the warranty
ATTENTION - AFIN DE RÉDUIRE LES RISQUES D'INCENDIE ET DE CHOC ÉLECTRIQUE
•
Lire toutes les instructions avant d'installer.
•
Manipuler le produit avec soin.
•
Ne pas dissimuler et faire passer les conducteurs exposés à travers un mur de bâtiment.
•
Afin de réduire les risques d'incendie et de brûlures, ne pas installer ce système d'éclairage là où les conducteurs dénudés peuvent être court-
circuités, ou entrer en contact avec des matériaux conducteurs.
•
Afin de réduire le risque de surchauffe et d'incendie potentiel, s'assurer que toutes les connexions sont bien serrées.
•
Ne pas installer aucun luminaire à moins de 6 pouces d'un rideau ou d'un matériau combustible similaire.
•
Ne pas modifier ou démonter le produit au-delà des instructions sous peine d'annuler la guarantie.
•
Ne pas respecter les avertissements de sécurité et des instructions d'installation annulera la garantie.
WIRING AND INSTALLATION:
1.
Turn Power off at circuit breaker (See FIG. 1)
FIG. 1
2.
Mounting
24VDC Class 2 remote power supply and WAC Wireless DMX LED
Controller at desired location. (See FIG. 2)
FIG. 2
Do not bend the tape light to
a diameter less than 4 inches
Do not bend the tape light
on a horizontal plane
Do not fold or
twist LED Tape
Do not cover LED tape
light with any materials
Do not power the LED
tape while attached to the
spool or tightly coiled
Avoid contact with sharp
objects
Install on stable
clean, dry surface
