Winch10 Cable - Cheat Sheet
MODE Functions
DMX ch. Function
0 Neutral function – motor stops
1 Position rough (Hi of a 16 bit DMX channel)
1 Positioning with auto TOP reset
2 Position fine (Lo of a 16 bit DMX channel)
2 Positioning with manual TOP reset
3 Set the maximum speed
3,4,5,6 Stops the motor unless specified otherwise
4 Set the soft TOP limit
7 Manual run up (DMX address = speed)
5 Set the soft BOTTOM limit
8 Manual run down (DMX address = speed)
6 Find hard TOP limit, moving up (reset speed)
9 Used for re-calibrating overload
7 Moving down
Before each use
−
Check that the winch is safely and correct installed/mounted.
−
Inspect the entire length of the lifting cable for bends,
damage, wear, broken or cut cord, and abuse.
−
Inspect the cable lock and thimble for damage, wear,
corrosion, or abuse.
−
Secure that the load is safely attached and weighs max 10 kg.
−
Check all limit switches.
−
Check the slack detection device
Warning! Do not use the winch if any damage or error is found!
Inspection points
Broken cable
Intact cable
AXEL GRUHNS VEJ 3, 8270 HØJBJERG, DENMARK · WWW.WAHLBERG.DK · TEL45 86 18 14 20
213.806.008
Date: 2017-10-24
