Operating and installation instructions
WAREMA Mobile system
WMS Weather station eco
Keep for future use!
Valid from 1 January 2020
2024730_d•en•2020-01-01
We reserve the right to make technical modifications
1
AUTION
C
Never press buttons on your transmitter arbi-
trarily without line of sight to the sun shad-
ing product. Children may not play with this
product – keep remote controls and trans-
mitters out of the reach of children!
OTICE
N
The receiver (e.g. the radio plug receiver,
radio tubular motor) cannot function in the
event of a power failure. Therefore, raise the
sun shading system early enough in case of
an approaching storm.
Due to both legal regulations for radio systems and struc-
tural factors, the operating range of radio remote controls
is limited. Sufficient radio reception must be ensured when
planning the project. This is especially the case where the
radio signal must pass through walls and ceilings. The
control unit should not be installed in the immediate vicin-
ity of metal components (steel beams, reinforced concrete,
fire doors).
Therefore, check that the receiver is functioning prop-
erly before the final installation.
Strong local transmitter systems (e.g. WLAN) with trans-
mission frequencies identical to those of the control
system may interfere with reception.
Installation
This device is designed for surface mounting on a build-
ing facade. It can also be mounted on a pole using the
included cable ties.
Included fixing materials:
2 screws 4.5 x 40 mm
2 screw anchors 6 mm
2 spacers for wall and ceiling installation (Fig. 2)
2 steel cable ties 360 mm
Use suitable fixing materials only. Depending on the sub-
structure (e.g. plastered outer insulation), other screws and
screw anchors may need to be used.
Important information on the installation loca-
tion
Attach the device outdoors at a readily accessible but
raised location.
Metal-clad buildings, domestic interference sources
(unshielded household appliances, television sets,
computers), supply lines and metallic objects such
as sheet metal enclosures must have a distance of at
least 0.5 m from the weather station.
General information
1
4
2
3
5
Fig. 1
WMS weather station eco
1 Solar panel
2 Photodiodes
3 Wind wheel
4 Joint
5
Mounting plate with cover
Three storage batteries for the power supply are found
under the cover.
The WMS Weather station eco enables the wireless control
of sun shading drives and is equipped with sensors for
brightness and wind speed. The station is solar powered.
The device transmits weather data to WMS-compatible
receivers.
Intended use
The WMS Weather station eco is an electronic device to
control WMS receivers. Any use other than the purpose
described in these instructions requires approval from the
manufacturer.
Safety instructions
ARNING
W
An automatically controlled mechanism
may begin to move unexpectedly!
Therefore, never place any objects in the area of move-
ment of an automatically controlled mechanism.
Disconnect the power supply of the controlled sun
shading products before maintaining or cleaning the
products.
