3. Place the roll of labels onto the center of
the paper roll mount.
4. Feed the paper, printing side face up,
under the Teflon bar and the paper guide,
and pass over the platen.
5. Adjust the yellow, center-biased paper
guide to slightly touch the edges of the
label backing.
6. Close the cover.
6. Install Drivers
Turn the printer on and wait for the LED to
turn green. Put the Driver CD into your CD
ROM drive. The driver install program should
run automatically but if it does not, run
PrnInst.exe on the root of the CD.
Follow the prompts to install the drivers and
set up the printer.
7. Calibrate
Turn the printer off.
Press and hold the feed button while turning
the printer back on. The LED will flash
orange then red five times and then flash
orange. Release the button when you see
the light flash orange two times.
The printer will detect the gap and advance
the labels. It will also print the printer’s
internal settings.
After the LED turns green again press the
feed key once.
8. Software
The printer is now ready to print labels.
Labels can be printed from Microsoft Word or
from label printing software. Wasp has
created a full featured label printing software
program called Labeler that is optimized to
print labels with the WPL305 printer.
9. Documentation
Several documents are included on the CD.
The user guide for the printer includes more
detailed setup instructions and a trouble
shooting guide.
#
000000
WPL305
Thermal Printer
Quick Start
Guide
© 2004 Wasp Technologies
Printer Top Cover
Support Bar
Paper Guide
Teflon Bar
Paper Roll Mount